The 2020 Chevy Traverse with the 3.6-liter V6 engine takes about 5 quarts (roughly 4.7 liters) of engine oil when performing a standard oil change with the filter replacement.
This article explains the official capacity, the recommended oil type, and practical tips for checking and topping up oil. Information is based on the vehicle’s Owner’s Manual and GM service data to ensure accuracy and current guidance.
Oil capacity and recommended oil for the 3.6L V6 in the 2020 Traverse
Here are the essentials you need to know about capacity and lubricant specification.
- Oil capacity: 5 quarts (4.7 L) with the oil filter.
- Recommended oil type: Synthetic 5W-30 (full synthetic preferred).
- Notes on viscosity: A 5W-30 grade covers most operating conditions; follow GM guidance for extreme climates or heavy-duty use.
In routine oil changes, you should plan for about 5 quarts of oil and a new filter. Always verify the level with the dipstick after adding oil to reach the proper mark.
Tips for oil changes and maintenance intervals
Practical steps and reminders when performing an oil change or tracking maintenance intervals.
- Oil change interval: Typically every 7,500 miles (12,000 km) or 12 months under normal conditions; refer to the GM maintenance schedule for your driving pattern.
- Check oil level after the change: Run the engine briefly, turn it off, wait a few minutes, then check the dipstick and top up in small increments if needed.
- Filter replacement: Replace the oil filter with every oil change to maintain capacity and filtration effectiveness.
Following these guidelines helps ensure proper engine lubrication, performance, and potential warranty considerations. If you operate the vehicle under severe conditions—towing, frequent short trips, or extreme temperatures—consult the dealer or the owner’s manual for adjusted intervals.
Summary
For the 2020 Chevrolet Traverse with the 3.6 L V6, expect to use about 5 quarts (4.7 L) of engine oil per oil change, using 5W-30 synthetic oil and a new filter. Confirm oil level with the dipstick after topping up, and adhere to the recommended maintenance schedule, adjusting for tough driving conditions as needed.