The 2019 Honda Pilot with the 3.5-liter V6 engine requires 5.5 quarts of engine oil when performing an oil change with a new filter, which is about 5.2 liters.
For context, this capacity refers to the typical amount needed to fill the engine after draining the old oil and replacing the filter. The recommended oil type is 0W-20 fully synthetic, and the exact amount can vary slightly depending on factors such as whether the filter is replaced, residual oil in lines, and how thoroughly the drain is completed. The following sections outline the official figures and practical steps to manage an oil change.
Official capacity and oil specification
Before presenting the key figures, here is the concise, practical information most drivers need for planning an oil change.
- Oil capacity (with filter): 5.5 quarts (approximately 5.2 liters).
- Recommended oil type: 0W-20 full synthetic.
In practice, most owners will pour about 5.5 quarts, start the engine to circulate the oil, then recheck the level with the dipstick and top off in small increments if needed to reach the full mark.
How to check oil level and refill safely
To ensure an accurate reading and avoid overfilling, follow these steps carefully.
- Warm the engine to operating temperature, then park on a level surface and turn off the engine. Wait a few minutes for oil to settle.
- Open the hood, locate the engine oil filler cap and the dipstick. Remove the dipstick, wipe it clean, reinsert it fully, and pull it out again to check the current level.
- If you are performing an oil change, drain the old oil completely and replace the oil filter, ensuring the drain plug is tightened to specification.
- Remove the oil filler cap and slowly add oil in small increments (about 1/2 quart / 0.25 liters at a time). Recheck the level with the dipstick after a short wait to let the oil settle.
- Continue adding until the dipstick shows the level within the Full range on the dipstick. Do not exceed the maximum mark.
- Replace the filler cap, wipe away any spilled oil, start the engine, and run it for a minute to circulate the oil. Turn off the engine and recheck the level once more after a few minutes of settling.
Following these steps helps ensure you achieve the correct oil level and avoid overfilling, which can harm engine performance.
Notes, tips, and caveats
Model-year variations and maintenance guidance
While 5.5 quarts (5.2 L) with a new filter is the standard specification for the 2019 Pilot 3.5 L, always double-check your owner’s manual or a dealership service bulletin for any model-year-specific notes or changes in recommended viscosity. Honda consistently recommends 0W-20 synthetic oil for this engine across many model years, but regional recommendations can vary slightly based on climate and driving conditions.
Typical oil-change interval guidance: under normal driving, Honda commonly cites about every 7,500 miles (12,000 kilometers). In severe service—such as frequent short trips, dusty conditions, towing, or extreme temperatures—the interval may be shortened to around 3,750 miles (6,000 kilometers). Always follow the maintenance schedule printed in your owner’s manual for your specific vehicle and region.
Summary
The 2019 Honda Pilot with a 3.5-liter V6 engine takes 5.5 quarts (roughly 5.2 liters) of engine oil when you perform an oil change with a new filter, using 0W-20 full synthetic oil. Use the dipstick to verify the level after filling, and respect the recommended change interval of about 7,500 miles under normal conditions or shorter intervals under severe service. If in doubt, consult the owner’s manual or your local Honda service center for precise guidance tailored to your vehicle.