The 2019 Dodge Journey equipped with the 3.6 L V6 engine takes about 6 quarts (5.7 liters) of engine oil when you replace the oil filter, and around 5 quarts (4.7 liters) if you’re not changing the filter. This capacity figure helps you plan an oil change and top-ups accurately.
Oil capacity figures
The figures below reflect common specifications for the 3.6 L Pentastar engine used in the 2019 Journey. They assume a standard oil filter replacement during an oil change.
- With oil filter change: 6 quarts (5.7 L)
- Without oil filter change: 5 quarts (4.7 L)
When performing an oil change, use the full 6-quart quantity with a new filter and then verify the level with the dipstick, topping up as needed to reach the full mark.
Oil type and maintenance guidance
Choosing the right oil viscosity and maintaining the level are important for the 3.6 L Pentastar in the 2019 Journey. The standard recommendation is a synthetic oil of suitable grade, typically around 5W-20, though exact specifications can vary by market and vehicle configuration. Always consult the owner’s manual or a dealer to confirm the exact viscosity and certification required for your climate and driving conditions.
Recommended oil grade and certification
In most 2019 Dodge Journeys with the 3.6 L engine, 5W-20 full synthetic is commonly recommended. Some regions or conditions may permit 5W-30; verify the exact specification in your manual or with a Chrysler dealership.
Top-up and service interval considerations
After an oil change, check the level with the dipstick and top up if needed to the full line. Following the manufacturer’s maintenance schedule for oil changes (which is often based on mileage and/or time) helps protect engine life; use the recommended oil type and keep receipts or service stamps for reference.
Additional notes and context
Oil capacity numbers can vary slightly by model year, trim, and regional specifications. If you recently performed an oil change outside the standard filter size or used a non-standard filter, re-check the total capacity required for your exact vehicle configuration. When in doubt, consult the owner's manual or contact a Dodge service center for confirmation.
Summary
For a 2019 Dodge Journey with the 3.6 L V6, plan on 6 quarts (5.7 L) of oil with a filter change and about 5 quarts (4.7 L) if no filter is replaced. Use the recommended synthetic oil (commonly 5W-20) and verify the exact specification in the owner’s manual, then check the level with the dipstick after adding oil to ensure an accurate fill.