The 2017 Toyota Tacoma with the 3.5-liter V6 typically uses about 6.0 quarts (5.7 liters) of engine oil with a filter, or roughly 5.0 quarts (4.7 liters) if the filter isn’t replaced. The recommended oil is 0W-20 full synthetic.
Engine oil capacity
Below are the standard capacity figures you’ll commonly see for the 2017 Tacoma’s 3.5 L V6.
- With oil filter: 6.0 quarts (5.7 L)
- Without oil filter: 5.0 quarts (4.7 L)
In practice, plan for about 6 quarts of oil when performing a full oil change with a new filter, but keep in mind minor variances can occur due to filter size and engine condition.
Oil type and maintenance
Choosing the right oil and following the maintenance schedule are essential for long-term engine health.
- Recommended oil grade: 0W-20 full synthetic (Toyota Genuine or equivalent)
- Capacity reminder: 6.0 quarts with filter; 5.0 quarts without filter
- Change interval: typically every 10,000 miles (16,000 km) under normal driving with synthetic oil; consult the owner’s manual for conditions that require more frequent changes
Regular oil checks and using the correct grade help ensure consistent performance and engine longevity.
Severe driving conditions
In very hot or very cold climates, or when the vehicle endures frequent short trips, heavy towing, or dusty environments, the maintenance schedule may be more aggressive. Refer to the owner’s manual for specifics tailored to your situation.
How to check and maintain oil levels
These steps help you verify the oil level and keep it within the proper range between changes.
- Park on level ground and turn off the engine for several minutes to let the oil settle.
- Open the hood, locate the dipstick, pull it out, wipe it clean, reinsert it fully, then pull it out again to read the level.
- If the oil is below the "Full" mark, add small amounts (about a 1/2 quart at a time), rechecking with the dipstick until the level sits between the marks.
- Use only the recommended oil (0W-20 full synthetic) and avoid mixing with incompatible oils beyond the manual’s guidance.
- Replace the oil filter with every oil change and reset any maintenance reminders as advised by Toyota.
Consistent checks help prevent engine wear and maintain optimal performance.
Summary
For the 2017 Toyota Tacoma 3.5 L V6, plan for about 6.0 quarts of oil with a filter (5.0 quarts if the filter isn’t replaced). Use 0W-20 full synthetic oil and follow the recommended 10,000-mile maintenance interval under normal driving, adjusting for climate and usage as outlined in the owner’s manual. Always verify the oil level with the dipstick after an oil change.