For a standard oil change on a 2016 Jeep Cherokee with the 2.4-liter Tigershark engine, you should plan to use about 4.5 quarts of engine oil, including the new filter.
The exact capacity can vary slightly by model year and trim, so it’s wise to double-check the owner’s manual or the service data for your specific vehicle. Oil capacity is generally listed as the amount required for a full change with a fresh filter, rather than a drain-and-fill without a filter, which can be lower by a half-quart or so.
Oil capacity specifics for the 2.4 L Tigershark engine
The following figures reflect common specifications for the 2016 Cherokee’s 2.4 L engine. They serve as a baseline, but you should verify against your vehicle’s manual or service data.
- Oil capacity with filter: approximately 4.5 quarts (4.3 L).
- Estimated capacity without replacing the filter: around 4.0 quarts, depending on drain conditions and oil remaining in the system.
- Recommended oil type: SAE 5W-20 synthetic or synthetic blend, meeting API SN+/ILSAC GF-5 standards.
- Fill guidance: after adding oil, run the engine briefly, turn off, wait for a moment, then recheck and top off to the full mark on the dipstick.
In most cases, the 4.5-quart figure covers the full oil change with a new filter installed. If you’re draining only the pan and not changing the filter, expect a lower total by roughly a half quart to a quart depending on your engine’s specifics and how much oil remains in the engine after draining.
Notes on variations
Engine variants, production date, and regional specifications can cause small differences in capacity. When in doubt, confirm with the owner’s manual or a Jeep dealer to ensure you’re using the exact specification for your VIN and trim level.
Recommended oil viscosity, maintenance tips, and how to verify
The 2.4 L Tigershark engine generally calls for 5W-20 oil, with a synthetic or synthetic-blend formulation, to balance cold-start protection and fuel economy. Some hot or extreme conditions may tolerate a 5W-30 alternative, but 5W-20 remains the standard recommendation for most U.S. operating conditions.
- Choose a high-quality oil filter from the OEM or a reputable aftermarket brand to ensure reliable filtration.
- Check the oil level when the engine is cool and the vehicle is on level ground; add oil in small increments if the dipstick is below the full mark after warm-up and cooling.
- Record the oil change date and mileage to stay on top of maintenance intervals and avoid overextension.
Ultimately, the best source for the exact capacity and the preferred oil specification for your Cherokee is the owner’s manual or the official service data for your specific VIN. If you’re unsure, a Jeep dealer or qualified technician can confirm the correct quantity and grade for your vehicle.
Summary
The 2016 Jeep Cherokee with a 2.4 L engine typically requires about 4.5 quarts of engine oil with a new filter for a complete oil change, using SAE 5W-20 synthetic or synthetic blend. Always verify with your owner's manual or dealership resources for your exact vehicle, and follow proper fill and verification steps to ensure optimal lubrication and engine health.