About 4.5 quarts (roughly 4.3 liters) of engine oil are required for a full oil change on the 2014 CR-V with the 2.4L engine, including the oil filter.
This capacity covers a standard change with a new filter. Actual amounts can vary a little depending on whether the filter is replaced and the exact service procedure used. Always verify the final level with the dipstick after the oil has settled.
Official capacity and what it means
Honda lists the 2.4L CR-V’s oil capacity at roughly 4.5 quarts (with the filter). This is the typical amount drained and replaced during a routine oil change with a new filter. If you skip replacing the filter, the needed quantity to reach the correct level can be slightly different, so plan for a similar total and always confirm with the dipstick.
Oil capacity (with filter)
4.5 quarts is the commonly cited figure for a full change with a new oil filter.
Oil capacity considerations
Variations can occur due to specific factory tolerances, oil filter size, or service procedure. Use the dipstick to confirm the final level after a change and add small amounts as needed to reach the correct mark.
Oil type and grade
For the 2014 CR-V 2.4L, Honda typically recommends synthetic 0W-20 or 5W-20, depending on climate and regional specifications. Always refer to the owner's manual or a Honda service advisor to confirm the exact viscosity for your environment.
Practical steps for an oil change and verification
Follow these steps to ensure you use the correct amount and achieve an accurate level when changing the oil on a 2014 CR-V 2.4L.
- Warm the engine slightly so the oil flows more easily.
- Drain the old oil and replace the oil filter.
- Pour in the new oil gradually, checking the level frequently.
- Reinstall the drain plug and verify all fittings are secure.
- Run the engine for a minute, turn it off, then wait a few minutes before rechecking the dipstick.
Concluding guidance: Always verify the final level on the dipstick and adjust in small increments if needed. If in doubt, consult a Honda dealer or qualified technician.
Summary
The 2014 Honda CR-V with a 2.4 L engine takes about 4.5 quarts (roughly 4.3 liters) of engine oil for a complete oil change with a new filter. Confirm the final level with the dipstick after the oil has settled, and use the oil grade specified in the owner's manual.