Skip to Content
103 State St East Jordan, MI, 49727
  • MON: Closed
  • TUES: 8:00AM - 6:00PM
  • WED: 8:00AM - 6:00PM
  • THUR: 8:00AM - 6:00PM
  • FRI: 8:00AM - 6:00PM
  • SAT: Closed
  • SUN: Closed
MORE >
  • Yelp
  • Google Business Profile
  • Facebook
7984 North St Central Lake, MI, 49622
  • MON: 8:00AM - 6:00PM
  • TUES: 8:00AM - 6:00PM
  • WED: 8:00AM - 6:00PM
  • THUR: 8:00AM - 6:00PM
  • FRI: Closed
  • SAT: Closed
  • SUN: Closed
MORE >
  • Yelp
  • Google Business Profile
  • Facebook

How much oil does a 2014 Honda Accord 3.5 take?

For a 2014 Honda Accord equipped with the 3.5-liter V6, the engine oil capacity is about 5.7 quarts (roughly 5.4 liters) when you replace the filter. This is the total capacity the engine can hold with a fresh filter, and most oil changes should plan to add about this amount. After draining, top off to the full mark using the dipstick and recheck after the oil settles.


Official capacity and how it’s measured


The 5.7-quart figure refers to the engine’s total oil capacity with a new filter installed. It represents the amount needed to fill the engine from empty to the recommended full level. If you drain the oil but do not replace the filter, you may remove slightly less oil; however, for a normal oil change, anticipate about 5.7 quarts and top up as needed after initial start-up and recheck.


What can cause minor differences


Variations can come from the exact engine variant, filter size, ambient temperature, oil grade, and whether the engine has accumulated deposits or worn seals. Always verify the level with the dipstick after the engine has settled.


How to execute an oil change and ensure the right amount


To guide you through the process and ensure you end up with the correct oil level, use the following steps and tips.



  1. Prepare tools, new oil filter, and the recommended oil quantity.

  2. Warm up the engine briefly, then turn it off and allow oil to drain into a pan.

  3. Remove the drain plug and empty the old oil; also replace the oil filter with a new unit.

  4. Install the drain plug, add oil gradually—start with about 4.5 to 5.0 quarts—and check the level with the dipstick.

  5. Continue adding small amounts until the dipstick shows the oil at the FULL mark; run the engine for a minute, recheck, and top off if necessary.


Bottom line: for a 2014 Honda Accord 3.5L V6, plan on about 5.7 quarts of oil during a standard oil change with a new filter, then adjust as necessary based on the dipstick reading after the oil has rested.


Oil type and where to find the right specification


Always use the oil viscosity and type recommended in your owner's manual or on the oil cap. Honda generally advocates a modern synthetic or blend that meets the vehicle’s requirements; check your manual for the exact specification for your region.


Summary: The 2014 Honda Accord 3.5 takes about 5.7 quarts of oil (5.4 liters) with a new filter. This capacity covers the engine’s total fill needed to reach the full level on the dipstick after a standard oil change. Always verify with the dipstick after the oil has settled and adjust if needed.

Ryan's Auto Care

Ryan's Auto Care - East Jordan 103 State St East Jordan, MI 49727 231-222-2199
Ryan's Auto Care - Central Lake 7984 North St Central Lake, MI 49622 231-544-9894

Ask any car or truck owner in Central Michigan who they recommend. Chances are they will tell you Ryan's Auto Care.