The engine oil capacity is about 4.5 quarts (4.3 liters) when performing a full oil change with a new filter.
The 2014 Honda Accord equipped with the 2.4-liter four-cylinder engine specifies the use of 0W-20 full-synthetic oil as the standard grade. The official capacity for a routine oil change with a new filter runs at approximately 4.5 quarts. Always confirm the exact requirement in the owner’s manual or with a local dealer, as regional specifications or updated service bulletins can influence the precise amount.
Capacity details and recommendations
Here are the key facts to keep in mind when planning an oil change for this model:
- Oil capacity (with filter): approximately 4.5 quarts (4.3 liters).
- Recommended oil type: 0W-20 full synthetic, API SN or newer.
- Note: Use a new filter and fill gradually, checking the level with the dipstick as you approach the full mark.
These figures reflect typical factory specifications for the 2014 Accord’s 2.4 L engine. Minor variations can occur due to filter choice or residual oil in the engine, so always verify the final level by checking the dipstick after a brief idle and re-tightening if needed.
How to perform an oil change (quick steps)
If you’re planning to do the oil change yourself, here are general steps to follow. For exact torque values and filter part numbers, consult the owner’s manual or a service manual for your vehicle.
- Warm the engine slightly, then turn it off and allow the oil to settle for a few minutes.
- Safely raise the car and place a drain pan beneath the oil pan; remove the drain plug to let the oil drain completely.
- Remove the old oil filter and install a new one, lightly coating the gasket with new oil.
- Reinstall the drain plug, then pour in the recommended oil (about 4.5 quarts for a full change with a new filter).
- Start the engine, run for a few minutes, then turn off and check for leaks. Let the oil settle, then check the dipstick and add oil as needed to reach the proper level.
Following these steps will help ensure you meet the correct capacity and maintain proper engine lubrication.
Summary
The 2014 Honda Accord 2.4 L engine requires roughly 4.5 quarts of oil (4.3 liters) when performing a full oil change with a new filter. Use 0W-20 full synthetic oil and verify the final level with the dipstick after filling. For exact specifications, consult the owner's manual or contact a Honda dealership.