Approximately 4.4 quarts (4.2 liters) of engine oil with a new filter; about 4.0 quarts (3.8 liters) if the filter is not changed.
In the 2013 Corolla with a 1.8-liter engine, the official capacity is typically around 4.4 quarts when the oil filter is replaced during an oil change. The exact amount can vary slightly by market and engine variant. Always consult the owner’s manual or a Toyota dealer for your specific model and region, and use the recommended oil grade for best performance.
Oil capacity for the 2013 Toyota Corolla 1.8 L
With oil filter
The following capacity is for a standard oil change with a new filter installed.
- 4.4 quarts (4.2 liters)
Note: This figure assumes a full oil change with a properly installed filter. Actual amounts can vary by market and engine variant.
Without oil filter
Capacity when the measurement excludes the oil filter.
- 4.0 quarts (3.8 liters)
After adding oil, always verify the level with the dipstick and adjust to the indicated Full mark if needed.
Recommended oil and maintenance
Beyond capacity, using the correct oil type and staying on schedule is essential for engine longevity. The following guidelines apply to most 2013 Corolla 1.8 L models, but confirm regional specifications in your manual.
- Viscosity: Toyota commonly recommends 0W-20 full synthetic engine oil for the 1.8 L engine in this generation; check the manual for your region’s approved grade.
- Oil type: Use an oil that meets API and ILSAC standards and is approved for Toyota engines.
- Maintenance intervals: Follow Toyota’s Maintenance Minder system or the owner’s manual to determine oil-change intervals; conventional oil changes are typically around every 5,000 miles (8,000 km), while synthetic oil may allow longer intervals as advised by the manual.
Always re-check the oil level after adding and running the engine, and refer to the vehicle’s manual or a dealer for precise guidance tailored to your location and trim.
Summary
The 2013 Toyota Corolla 1.8 L engine uses about 4.4 quarts (4.2 liters) of oil with the filter, or roughly 4.0 quarts (3.8 liters) without the filter. Use 0W-20 synthetic oil in most regions and follow the Maintenance Minder instructions for service intervals. For exact specs, consult the owner’s manual or your local Toyota dealer.