The engine takes about 4.7 quarts of oil (approximately 4.4 liters) when changing the filter. Use 5W-20 viscosity in most markets and always verify the level with the dipstick after the change.
Understanding the engine and its oil needs
The 2013 CR-V uses Honda’s 2.4 L inline-4 engine. Knowing the correct oil capacity helps ensure proper lubrication, engine longevity, and optimal performance. The figures below refer to typical US-spec models; regional variants may have minor differences.
Capacity details
Before listing the specific quantities, note that these numbers represent the engine’s total oil capacity with the filter in place, as used during a standard oil change.
- With filter: 4.7 quarts (4.4 L)
- Without filter: 4.3 quarts (about 4.1 L)
When performing an oil change, start with the full-with-filter figure and adjust as needed after checking the dipstick.
Oil type and filling procedure
Honda typically specifies 5W-20 oil meeting API SN or higher for the 2013 CR-V’s 2.4 L engine. Use a quality oil (synthetic, synthetic-blend, or conventional) that meets Honda’s specification, and replace the oil filter at every change. After filling, run the engine briefly and recheck the level; top off to the full mark as necessary.
Summary: For the 2013 Honda CR-V 2.4 L, plan to use about 4.7 quarts of oil with the filter installed (roughly 4.4 liters), typically 5W-20 API SN or higher. Always confirm the exact specification in your owner’s manual or with a dealer if you have region-specific variations.