About 5.5 quarts (roughly 5.2 liters) of engine oil with a fresh filter are typically required for a full drain-and-fill on the 2010 Acura TL 3.5. Always verify with your owner's manual and dealership if you have a special edition or a modified engine.
Capacity, oil type, and service notes
Here is the core information you need to know about the TL 3.5's capacity and maintenance considerations.
Official capacity and oil grade
The standard oil capacity with a new filter is 5.5 quarts (5.2 liters). Acura recommends an engine oil viscosity of 5W-20 or 0W-20 depending on climate and operating conditions; check the owner's manual for your vehicle's exact specification and any regional advisories.
For those who are performing more extensive oil services where the filter is not replaced, the total in-tank oil will be slightly less, but the official capacity assumes a full drain and new filter.
Unpacking the process: steps to change the oil
When changing the oil, it helps to follow a standard drain-and-fill approach and verify the final level with the dipstick after a brief engine run and cool-down.
- Drain the used oil from the sump and replace the oil filter with a new one.
- Refill with 5.5 quarts of the recommended oil type and viscosity (5W-20 or 0W-20 as specified).
- Run the engine for a minute, turn off, wait a few minutes, then check the dipstick and add oil in small increments as needed to reach the full mark.
Note: The exact amount may vary slightly due to filter design or residual oil in the engine; always verify with the dipstick.
Maintenance intervals and climate considerations
Our standard guidance is to perform oil changes every 5,000-7,500 miles under normal driving conditions. In severe service (short trips, heavy traffic, extreme temperatures), more frequent changes may be warranted. Always follow the schedule in your owner's manual and any dealership advisories for your VIN.
Summary
The 2010 Acura TL 3.5 typically requires about 5.5 quarts of engine oil (5.2 liters) when performing a drain-and-fill with a new filter, using 5W-20 or 0W-20 oil as recommended. Verify exact specifications in the owner's manual and confirm the level with the dipstick after the oil change.