The engine oil capacity for a 2008 Honda CR-V is about 4.5 quarts (4.3 liters) when you replace the oil filter.
In standard practice, the 2008 CR-V uses a 2.4-liter inline-four engine. The official data typically quotes 4.5 quarts (4.3 L) with a new filter; without the filter, the capacity is around 4.0 quarts (3.8 L). Regional variations may apply, so consult the owner's manual or a local Honda service center for your exact specification.
Oil capacity specifics
The following figures apply to the U.S.-market 2008 CR-V with the 2.4 L engine and assume a replaced oil filter.
- With oil filter: 4.5 quarts (4.3 liters)
- Without oil filter: about 4.0 quarts (3.8 liters)
After an oil change, run the engine for a couple of minutes, shut off, wait a few minutes, then recheck the level on the dipstick and add oil in small amounts if needed to reach the full mark.
Region and variant notes
Some export models or late-production revisions may have slight differences in capacity. The 4.5-quart figure with the filter is the standard reference for the 2008 CR-V's 2.4 L engine in most regions. Always confirm with the manual or dealer if yours differs.
Practical maintenance tip
Use the recommended oil viscosity (for example 5W-20 or 5W-30 depending on climate and engine spec) and replace the oil filter every oil change to maintain proper capacity and protection.
Summary: For a 2008 Honda CR-V with the 2.4 L engine, plan on about 4.5 quarts (4.3 L) of engine oil when changing the oil with a new filter; about 4.0 quarts (3.8 L) if you omit the filter. Always verify the level with the dipstick after refilling and consult the owner's manual for your market-specific guidance.