This article answers how much oil the 2008 Charger with the 2.7-liter engine holds, and it includes guidance on oil type and how to verify the level after an oil change.
Approximately 5 quarts (about 4.7 liters) of engine oil are typically required for a full drain-and-fill when changing the oil on the 2008 Charger with the 2.7L V6, using a new oil filter. The level should be confirmed with the dipstick after filling. Always consult the owner's manual for your exact vehicle and climate conditions, as capacities can vary slightly by model and aftermarket modifications.
Oil capacity and practical guidance
Here are the key points to keep in mind when planning an oil change for this engine.
- Oil capacity with a new filter: about 5 quarts (4.7 liters).
- Recommended oil viscosity: typically 5W-20 or 5W-30, as specified in the owner’s manual for your climate and whether you use conventional or synthetic oil.
- Checking level: after adding oil and running the engine briefly, check the dipstick and fill to the full mark, avoiding overfill.
Note: If the engine has been modified or if you’re using a different filter or aftermarket parts, the exact capacity can vary slightly. Always confirm with the manual or a Chrysler/Dodge dealer for your specific vehicle.
Step-by-step oil change checklist
Use this sequence to perform a proper oil change and reach the correct fill level.
- Park the car on level ground and gather all supplies (oil, filter, wrench, drain pan, funnel).
- Warm the engine to operating temperature to help drain the oil more completely.
- Drain the old oil from the pan and remove the old filter; install a new filter.
- Pour in about 5 quarts of oil, then replace the oil cap and run the engine for a minute to circulate the new oil.
- Turn off the engine, let it settle for a few minutes, then check the dipstick and add more oil if needed to reach the full mark.
Always check for leaks after an oil change and dispose of used oil properly at an approved recycling facility.
Summary
The 2008 Dodge Charger with the 2.7L engine typically requires about 5 quarts of engine oil when performing an oil change with a new filter, with the exact amount best verified by the dipstick and the owner’s manual. Use the recommended viscosity (commonly 5W-20 or 5W-30) and follow the proper steps to ensure the level is correct.