A 2004 Ford 5.4L V8 typically takes about 6 quarts of engine oil with a new filter (roughly 5.7 liters). The exact amount can vary slightly by model and whether the oil filter is replaced during the change.
In 2004, Ford used the 5.4-liter Triton V8 across several models, including the F-150, Expedition, and Navigator. While the overall capacity is similar across these applications, it’s wise to verify the specific figure in your vehicle’s owner’s manual or a service guide for your exact configuration. The recommended oil viscosity for that year generally sits around 5W-20 or 5W-30, depending on climate and operating conditions.
Oil capacity for the 2004 5.4L Triton V8
Before listing the standard capacity, note that this figure assumes a full oil change with a new filter installed. Variations may apply if you skip the filter or perform specialty servicing.
- 6 quarts (5.7 liters) of engine oil with a new filter for most 2004 5.4L Triton V8 applications (F-150, Expedition, Navigator).
In practice, this means budgeting for roughly six quarts of oil to complete a standard change, plus a new filter and a small additional amount if synthetic oils are used or the engine has higher mileage and requires extra topping off after testing.
Note on oil grade and checking level
Always use the grade recommended in your owner's manual. For many 2004 Ford applications, this is typically 5W-20 or 5W-30. After filling, run the engine a few minutes and recheck the level on the dipstick, topping off as needed to reach the full mark.
Summary
For a 2004 Ford 5.4L V8, plan on about 6 quarts of engine oil with a new filter during a standard oil change. Confirm the exact capacity for your specific model and variant in the owner’s manual, and use the recommended oil grade for the climate you operate in.