Approximately 5 quarts (4.7 liters) of engine oil, plus a new filter, are needed for a standard oil change on the 2020 Pacifica equipped with the 3.6-liter V6.
In more detail, the Pacifica’s 3.6L Pentastar V6 uses about 5 quarts of oil when changing the oil with a fresh filter. The official spec lists 5 quarts (4.7 L) with a filter and roughly 4.5 quarts (4.3 L) without a filter. Actual amounts can vary slightly by model year and filter size, so always verify the exact quantity in the owner's manual and confirm the level with the dipstick after refilling.
Capacity specifics for the Pacifica 3.6L
The figures below reflect the standard oil capacity for typical Pacifica 3.6L engines. For precise values tied to your vehicle’s VIN, consult the owner’s manual or a dealer service bulletin.
Oil capacity (with filter):
- 5 quarts (4.7 L)
- Oil capacity (without filter): 4.5 quarts (4.3 L)
After adding oil, run the engine briefly, then recheck the dipstick and top up as needed to reach the full mark.
Viscosity and maintenance tips
For most Pacifica models, the recommended oil viscosity is 5W-20. Use an API SN or higher certified oil and install a new oil filter during the change. Follow the maintenance intervals in the owner’s manual and keep records of the service.
- Choose a 5W-20 oil that meets API SN or higher and is suitable for your climate.
- Install a new oil filter and ensure the drain plug washer is in good condition; torque to the manual specifications.
- Dispose of used oil and the old filter at an authorized facility; reset any oil-change indicators if your vehicle is equipped with them.
Adhering to these steps helps ensure proper lubrication and environmental responsibility.
Summary
The 2020 Pacifica with the 3.6L V6 typically requires about 5 quarts of oil with a new filter (roughly 4.7 liters). Always verify the exact amount using the dipstick after an oil change and consult the owner's manual for model-year-specific guidance.