Skip to Content
103 State St East Jordan, MI, 49727
  • MON: Closed
  • TUES: 8:00AM - 6:00PM
  • WED: 8:00AM - 6:00PM
  • THUR: 8:00AM - 6:00PM
  • FRI: 8:00AM - 6:00PM
  • SAT: Closed
  • SUN: Closed
MORE >
  • Yelp
  • Google Business Profile
  • Facebook
7984 North St Central Lake, MI, 49622
  • MON: 8:00AM - 6:00PM
  • TUES: 8:00AM - 6:00PM
  • WED: 8:00AM - 6:00PM
  • THUR: 8:00AM - 6:00PM
  • FRI: Closed
  • SAT: Closed
  • SUN: Closed
MORE >
  • Yelp
  • Google Business Profile
  • Facebook

How much oil does a 1.8 L HRV take?

Approximately 3.5 liters (about 3.7 quarts) of engine oil when doing a full oil change with a new filter. Without the filter, the capacity is roughly 3.1 liters (about 3.3 quarts).


The 1.8-liter engine used in many Honda HR-V models has a specific oil capacity that can vary slightly by year and market. This article provides typical official values and practical guidance for checking and topping up oil.


Official oil capacity for the 1.8 L HR-V


Before listing the capacities, note that the exact figure can vary by model year and market. Use the dipstick and the vehicle’s owner's manual or service manual for your precise specification.



  • With oil filter (the usual quantity you’d add during a standard oil change): 3.7 quarts (3.5 liters).

  • Without oil filter: 3.3 quarts (3.1 liters).


These values reflect common Honda service literature for the 1.8 L HR-V across many markets. Always confirm your model/year in the official manual or with a dealer if you’re unsure.


How to check the oil level and top up safely


Use these steps to verify your oil level and add oil as needed without overfilling.



  1. Park the vehicle on level ground and turn off the engine. For the most accurate reading, wait a few minutes for the oil to settle.

  2. Open the hood and locate the dipstick. Remove it, wipe clean, reinsert fully, then pull it out again to read the level.

  3. If the oil level is below the “Full” mark, add oil a little at a time, checking the level frequently to avoid overfilling.

  4. Use the oil type and viscosity recommended in your owner's manual (common choices for modern HR-Vs include 0W-20, with some markets using 5W-30). Add gradually, then recheck with the dipstick after a few minutes of engine idle or after a short drive and return to a level-between-marks.

  5. Once at the correct level, recheck for leaks and replace the oil cap securely. If you recently changed the filter, ensure the seal is snug and clean any spilled oil.


Bottom line: stick to the official capacity figures for your year/market and always reference the owner's manual for the exact oil grade and capacity. Do not overfill, as excess oil can cause engine damage.


Summary


For the 1.8 L HR-V, plan on about 3.5 liters (3.7 quarts) of oil when performing an oil change with a new filter, and about 3.1 liters (3.3 quarts) if you’re omitting the filter. Always verify the exact capacity for your specific model year and market in the owner's manual or via a Honda dealer. Use the recommended oil viscosity and check the level with the dipstick after a short period of running the engine and cooling down.

Ryan's Auto Care

Ryan's Auto Care - East Jordan 103 State St East Jordan, MI 49727 231-222-2199
Ryan's Auto Care - Central Lake 7984 North St Central Lake, MI 49622 231-544-9894

Ask any car or truck owner in Central Michigan who they recommend. Chances are they will tell you Ryan's Auto Care.