In short, replacing the wheel bearing on a 2010 Town & Country typically runs about $300–$700 installed in the United States, with front hub assemblies generally costing more than standalone bearings and rear bearings sometimes priced higher depending on labor and parts chosen.
The price you’ll pay depends on several factors, including whether you replace the hub assembly or just the bearing, whether the work is done on the front or rear axle, the choice of aftermarket versus OEM parts, and the local labor rate. This article breaks down the main price drivers and typical ranges to help you shop with confidence.
What you’re paying for
Prices for wheel bearing work on a 2010 Town & Country are influenced by a few key factors. The following list outlines the most significant ones to consider when budgeting for repair:
- Part type: hub assembly (bearing already seated in a hub) versus a standalone bearing kit. Hub assemblies are often easier to install and may include studs, seals, and the ABS tone ring.
- Vehicle position: front-wheel-drive minivans commonly have hub assemblies on each front wheel; rear bearings may be less accessible or require different procedures.
- Brand and warranty: aftermarket parts are usually cheaper but may have shorter warranties, while OEM parts tend to cost more but come with manufacturer warranties.
- Labor rates and shop type: dealerships typically charge more per hour than independent shops, and some may offer flat-rate pricing for hub replacements.
- Additional components: seals, studs, brake rotors, ABS sensors, or brake service may be needed during the job, adding to the total.
Because many variables affect final cost, consider obtaining multiple quotes that include parts and labor, and clarify whether the price is for the hub assembly or the bearing alone.
Typical price ranges for a 2010 Town & Country
Below are approximate price ranges you’re likely to see in the U.S. market as of 2024–2026. Regional differences and promotions can shift these numbers.
- Front wheel hub assembly (aftermarket parts, installed): part price around $100–$250; total installed often $300–$600 depending on labor.
- Front wheel hub assembly (OEM parts, installed): part price around $200–$500; total installed often $500–$700 or more depending on labor.
- Front bearing only (bearing kit, if the hub is not replaced): parts roughly $50–$150; labor typically $100–$250; total $150–$400.
- Rear wheel bearing hub assembly (aftermarket, installed): part price around $250–$600; total installed often $500–$900 depending on labor.
- Rear wheel bearing hub assembly (OEM, installed): part price around $350–$750; total installed may exceed $900 in some regions.
Keep in mind that labor costs and taxes can push totals higher or lower. Always request written quotes that break out parts and labor, and ask about warranties on both parts and workmanship.
Summary
For a 2010 Town & Country, anticipate a front hub replacement or bearing work to cost roughly $300–$700 installed, with rear bearings typically falling in the $500–$900 range depending on part choice and regional labor rates. The key to a good price is understanding whether you’re buying a hub assembly or a bearing kit, comparing OEM and aftermarket options, and collecting multiple quotes that clearly itemize parts and labor. Planning ahead and asking about warranties can help you avoid surprise costs.