The typical installed cost for a fuel pump replacement on a 2014 GMC Acadia is about $400 to $1,100, depending on part type (OEM vs aftermarket) and local labor rates.
The 2014 Acadia uses an in-tank fuel pump module that powers the engine by delivering gasoline from the tank. Replacing it can involve draining the fuel, accessing the tank (which may require dropping or partially removing components), and potentially swapping the sending unit, seals, and related hardware. Prices vary by brand, warranty, and regional labor rates, so quotes can differ considerably.
What affects the price
Prices can vary based on part quality, brand, and the complexity of the job. Here are the main factors that influence the total cost.
- Part type and brand: OEM GM parts tend to be more expensive than aftermarket or remanufactured units.
- Engine and vehicle specifics: While most 2014 Acadias use the same pump module, variations in trim and options can affect compatibility and price.
- Labor rates and shop location: Labor rates vary widely by region and shop type (dealer, independent shop, or chain store).
- Additional components or services: Some jobs require new seals, sending units, fuel lines, or a fuel system check, which adds to the cost.
Understanding these factors helps when comparing quotes and planning for the total expense.
Parts price ranges
Before quoting labor, here are typical price ranges for the fuel pump module itself. Note that exact prices depend on the supplier and whether the unit is OEM, aftermarket, or remanufactured.
- OEM GM fuel pump module (new): roughly $260–$550
- aftermarket/new fuel pump module: roughly $100–$350
- remanufactured fuel pump module: roughly $180–$350
When choosing parts, consider warranty coverage and compatibility with your specific 2014 Acadia model and engine.
Labor and installation time
Labor costs depend on local rates and the time required to access and replace the pump. Here are typical ranges to set expectations.
- Estimated labor time: usually 2–4 hours (some setups may be longer in tight spaces or if complications arise)
- Typical labor rate: about $75–$150 per hour, depending on region and shop
- Estimated total labor cost: roughly $150–$600
Combining parts and labor, the total installed price commonly falls in the broad range of several hundred to over a thousand dollars, depending on the choices and local conditions.
Shop smart: how to save
To get the best value, consider these strategies when planning a fuel pump replacement.
- Get multiple quotes from both dealerships and independent shops to compare prices and labor estimates.
- Ask for a full pump module (pump plus sending unit) with a warranty, rather than just the pump alone, to avoid compatibility issues.
- Consider reputable aftermarket or remanufactured units with solid warranty coverage, balancing price and reliability.
- Clarify whether there are any additional charges, such as tank draining, core charges, or disposal fees.
- Inspect related components (fuel lines, seals, and filters) and address them if needed to prevent future failures.
Summary
Replacing the fuel pump on a 2014 GMC Acadia involves both the cost of the pump module and the labor to install it. Part prices vary by OEM vs aftermarket, while labor costs depend on location and shop rates. On balance, most buyers should budget roughly $400 to $1,100 for a complete installed replacement, though quotes can be lower or higher based on part choices and regional pricing. Always compare several estimates, verify part compatibility, and choose a option that balances price with warranty and reliability.