Skip to Content
103 State St East Jordan, MI, 49727
  • MON: Closed
  • TUES: 8:00AM - 6:00PM
  • WED: 8:00AM - 6:00PM
  • THUR: 8:00AM - 6:00PM
  • FRI: 8:00AM - 6:00PM
  • SAT: Closed
  • SUN: Closed
MORE >
  • Yelp
  • Google Business Profile
  • Facebook
7984 North St Central Lake, MI, 49622
  • MON: 8:00AM - 6:00PM
  • TUES: 8:00AM - 6:00PM
  • WED: 8:00AM - 6:00PM
  • THUR: 8:00AM - 6:00PM
  • FRI: Closed
  • SAT: Closed
  • SUN: Closed
MORE >
  • Yelp
  • Google Business Profile
  • Facebook

How much freon does a 2010 Honda Civic take?

The quick answer: the 2010 Honda Civic uses R-134a refrigerant and typically requires about 20–24 ounces (roughly 0.56–0.68 kilograms) of refrigerant to reach the proper charge, with about 4–6 ounces (roughly 110–170 milliliters) of PAG oil in the system. Exact figures can vary by model and condition.


What follows is a breakdown of the typical capacity and related notes, followed by guidance on verification and safety considerations.


Typical refrigerant capacity and oil for a 2010 Civic



  • Total refrigerant capacity (R-134a): about 20–24 ounces (1.25–1.5 pounds), equivalent to roughly 0.56–0.68 kilograms.

  • PAG oil charge: typically around 4–6 ounces (about 110–170 milliliters), depending on compressor and service history.

  • Notes: Some Civics may vary by trim, and any retrofit to a different refrigerant (such as R-1234yf) changes the required amounts and procedure.


To ensure accurate charging, always verify with the vehicle's service manual or the under-hood label, and use proper weighing equipment during charging.


How to verify and handle the charge safely


Before listing the steps, technicians generally follow these guidelines to avoid under- or overcharging:



  • Work with the vehicle engine off and the A/C system depressurized before opening service ports.

  • Weigh refrigerant using a scale and ensure you are charging with the correct R-134a grade.

  • Do not mix refrigerants; ensure oil type and amount are appropriate for the compressor (PAG oil specified for R-134a systems).

  • Monitor high- and low-side pressures after charging; avoid overcharging which can damage the compressor or reduce cooling efficiency.


Bottom line: If in doubt, take the vehicle to a certified A/C technician to avoid leaks, improper charges, or potential harm.


Summary


For a 2010 Honda Civic, the typical refrigerant charge is around 20–24 ounces of R-134a, plus about 4–6 ounces of PAG oil, with exact amounts depending on the sedan/coupe variant, system condition, and any retrofits. Always confirm with the owner's manual or a service label, and consider a professional service to ensure a proper, leak-free charge.

Is 4 lbs of refrigerant a lot?


It is essential to ensure enough refrigerant in your air conditioner, as too little can cause the system to work less efficiently, and too much can be dangerous. The general guideline used when calculating the amount of Freon in a residential A/C unit is 2-4 pounds per ton of cooling.



What kind of refrigerant does a 2010 Honda Civic use?


What are the top-rated Refrigerants that fit the 2010 Honda Accord? The one 2010 Honda Accord Refrigerant we have in stock is the R-134a PAG 46 AC Oil Lubricant: With ICE 32 For Improved Cooling, 8 oz.



How much to recharge Freon in Honda Civic?


between $249 and $334
The average cost for a Honda Civic AC Recharge is between $249 and $334. Labor costs are estimated between $182 and $268 while parts are typically priced around $67.



How much Freon does a 2010 Honda Civic hold?


Using less of the recommended. Amount can cause the compressor to overheat. And fail 2009 Honda Civic refrigerant capacity the 2009 Honda Civic has a refrigerant capacity of 17.


Ryan's Auto Care

Ryan's Auto Care - East Jordan 103 State St East Jordan, MI 49727 231-222-2199
Ryan's Auto Care - Central Lake 7984 North St Central Lake, MI 49622 231-544-9894

Ask any car or truck owner in Central Michigan who they recommend. Chances are they will tell you Ryan's Auto Care.