Typically, you can expect to pay about $300–$700 per axle to replace a wheel bearing on a 2016 Jeep Compass, including parts and labor. Front-wheel hub assemblies are the common failure point and often push the overall cost higher than rear replacements.
What goes into the cost
Several factors influence the final price, including which axle needs service, the type of part used, the shop’s labor rates, and your location. Here is how those elements typically break down for a Compass.
Key cost drivers
The 2016 Compass generally uses a wheel hub assembly that contains the bearing and often an ABS sensor. Replacing this assembly is usually done on the front axle, though rear-hub replacements are possible on some configurations. Costs vary with part type (OEM vs aftermarket) and the labor required to remove the old hub and install the new one, plus any sensor-related work or brake reassembly.
Typical price ranges
Below are typical price ranges for wheel bearing/hub replacement on a 2016 Jeep Compass. These figures include parts and labor and reflect common U.S. market rates. Prices can differ by region and shop.
- Front axle replacement (hub assembly): Part cost typically $80–$350, labor $150–$350, total roughly $230–$700 per axle.
- Rear axle replacement (hub assembly): Part cost typically $60–$250, labor $150–$350, total roughly $210–$600 per axle.
Dealerships often charge toward the higher end of the range, while independent shops or chain auto centers may offer lower prices. OEM (dealer) parts tend to cost more than aftermarket options, but many buyers opt for OEM for warranty or reliability reasons.
What to expect from a shop
Most shops replace the entire wheel hub assembly rather than servicing a loose bearing, which generally saves time and reduces future issues. You may encounter a diagnostic or shop supplies fee, and an alignment might be recommended if the repair disturbed wheel alignment or if tire wear is evident.
Here is a typical sequence technicians follow during a wheel hub replacement on the Compass:
Before listing the steps, note: the service workflow can vary slightly by shop and drivetrain configuration.
- Secure the vehicle on a level surface and chock the wheels; lift and support with a jack stands.
- Remove the wheel and brake components to access the hub.
- Disconnect the ABS sensor and detach the hub from the knuckle.
- Install the new hub assembly, reconnect the sensor, and reassemble the brake components.
- Torque fasteners to specification, reinstall the wheel, and lower the vehicle.
- Perform a test drive to verify proper operation and clearance, and address any ABS or braking warnings if needed.
After the replacement, monitor for any ABS or brake issues and consider a tire rotation or alignment if you notice unusual wear or handling changes.
Tips for saving money
Before listing savings tips, this brief guide outlines practical ways to approach the replacement cost.
- Shop around for quotes from independent shops and dealers to compare prices on OEM vs aftermarket hubs.
- Ask if the price includes a new hub assembly, sensors, and brake reassembly; confirm any diagnostic fees.
- Consider bundled services (alignment, brake inspection) if you’re due for those services at the same visit.
- Check for warranties on parts and labor; some shops offer longer coverage on hub assemblies.
Prices can vary significantly by region and vehicle configuration. Always obtain a written estimate that itemizes parts and labor before authorizing work.
Warranty and maintenance considerations
Wheel hub assemblies typically carry a warranty that covers defective parts, while labor warranties vary by shop. If you’re unsure about the problem, obtain a second assessment to confirm that the hub assembly is the root cause of noise or vibration before authorizing replacement.
Summary
For a 2016 Jeep Compass, replacing a wheel bearing (hub assembly) generally costs about $300–$700 per axle, depending on whether the front or rear axle is involved, the chosen parts (OEM vs aftermarket), and local labor rates. Front hub failures are more common and often drive most of the expense. Always gather multiple estimates, confirm whether the price includes the hub, sensor, and brakes, and consider warranty coverage when selecting parts and a shop.