Replacing a wheel bearing (usually the hub assembly) on a 2013 Hyundai Elantra typically costs about $300–$550 per wheel at an independent shop, and about $500–$900 per wheel at a dealership. Costs vary by location, whether you replace the bearing only or the full hub, and by which axle is affected (front or rear).
What drives the price
Key factors that influence the final bill include the choice of parts, the shop's labor rate, the axle involved, and whether any additional services are needed or recommended after replacement. The following sections break down typical ranges and scenarios.
- Part choice: bearing-only versus hub assembly. In most Hyundais, the wheel bearing is replaced as part of a hub assembly; hub assemblies typically cost more than bearings sold separately but may simplify installation.
- Axle location: front bearings/hubs are more commonly replaced than rear on these cars, and pricing differs by front vs rear due to part availability and complexity.
- Labor rates: independent shops generally charge less than dealer service departments; regional cost of living also matters.
- Aftercare: alignment is not always required but is sometimes recommended; ABS sensor and tone ring replacement can add to cost.
- Warranty and brand: OEM parts and Hyundai-certified service may cost more but carry longer warranties.
Bottom line: expect a per-axle price range that varies with the above factors, and plan for a bit of price variability between shops and regions.
Typical price ranges by scenario
Before you shop, it helps to understand the most common price brackets. The following ranges reflect typical U.S. prices as of 2024–2025 and may vary by location and provider.
- Independent shop – hub assembly replacement (front or rear): Parts roughly $150–$350; labor about $100–$250; total per axle typically $250–$600.
- Independent shop – bearing-only replacement (rare for modern cars): Parts $50–$150; labor $70–$180; total per axle $120–$330.
- Dealership – hub assembly replacement: Parts $200–$350; labor $150–$350; total per axle $350–$700 (some contexts up to $900).
Note: Some cars require a dealership-level diagnostic to confirm axle fault, and some shops quote a combined price for both front wheels if both bearings need replacement.
What to expect during the service
Most repairs involve removing the wheel, caliper, and rotor, separating the knuckle, pressing out the old bearing, and installing a new hub assembly. If the bearing is replaced without hub assembly, the process is similar but includes pressing the bearing into the knuckle and reassembling with the axle nut and ABS components. After installation, a wheel alignment is typically recommended if other suspension components were disturbed or if steering feel is off, and the shop may check the ABS sensor circuitry for fault codes.
In rare cases, additional components such as brake rotors, calipers, or axle shafts may require replacement if they show wear or damage during the service.
Tips for saving money and getting a good repair
Shop around for quotes from at least three shops, ask for itemized estimates, confirm whether the price includes labor, hub assembly, ABS sensor, and any disposal fees. Check whether the price includes a short parts warranty and a labor warranty. If you own the car, consider whether OEM or aftermarket parts balance price and reliability for your budget.
Summary
Replacing a wheel bearing on a 2013 Hyundai Elantra typically costs around $250–$550 per wheel at an independent shop, and about $500–$900 per wheel at a dealership, depending on whether a hub assembly or bearing-only replacement is performed and which axle is involved. Costs vary by location, part choice, and service provider. Getting multiple, itemized quotes helps ensure a fair price while securing quality parts and workmanship.
Conclusion
This article provides a practical overview of costs and decision points for wheel bearing replacement on a 2013 Hyundai Elantra, emphasizing regional price differences, part options, and the importance of clear quotes and warranties.
What is the most common problem with a 2013 Hyundai Elantra?
Owner Reported Trouble Spots
- Engine Cooling.
- Noises/Leaks.
- Engine Minor.
- Paint/Trim.
- Body Hardware.
- Brakes.
- Transmission Major.
- Drive System.
How much to replace wheel bearing 2013 Hyundai Elantra?
The average cost for a Hyundai Elantra Wheel Bearing Replacement is between $215 and $410 but can vary from car to car.
Can I drive a car with a bad wheel bearing?
No. It is not safe to drive with a bad wheel bearing. A broken wheel bearing can seize, overheat, or even cause the wheel to detach completely.
Is it worth fixing a wheel bearing?
Driving with bad wheel bearings impacts the safety of a vehicle, and it could cause a serious car accident. We do not advise driving on them when they fail and recommend getting them checked out as soon as possible.