For a 2007 Chrysler 300, most drivers should expect to spend roughly $300 to $650 to replace the starter at a shop. This range reflects differences in engine type, whether you choose a remanufactured or new starter, and local labor rates.
The 2007 Chrysler 300 came with two engine options: a 3.5-liter V6 and a 5.7-liter Hemi V8. The cost to replace the starter varies with which engine you have, whether you opt for a remanufactured or brand-new unit, and how much labor your local shop charges. Below is a breakdown of typical prices and factors, with guidance for getting a firm quote.
Parts cost by engine
Prices shown are typical ranges for starters and do not include labor. They reflect common aftermarket and remanufactured options available to most repair shops.
- 3.5L V6:
- Remanufactured starter: roughly $70–$150
- New aftermarket starter: roughly $120–$250
- Core charge: usually $0–$30
- 5.7L Hemi V8:
- Remanufactured starter: roughly $120–$250
- New aftermarket starter: roughly $180–$300
- Core charge: usually $0–$40
Prices vary by supplier, geographic region, and the specific part number needed for your vehicle's VIN. Always verify compatibility and warranty terms when shopping.
Labor costs and time
Labor costs depend on shop rate and how accessible the starter is. The following ranges reflect typical scenarios encountered by independent shops and dealerships.
- Typical replacement time: about 1.0 to 2.5 hours for a straightforward job; up to 3 hours in some cases, especially on the 5.7L engine or if extra disassembly is required.
- Hourly labor rates:
- Independent repair shop: roughly $75–$125 per hour
- Dealership: roughly $100–$150 per hour
- Mobile/mechanic service: roughly $90–$150 per hour
- Estimated labor cost range: roughly $75–$375 (depending on hours and rate)
Note that some shops may bundle diagnostic fees into the labor estimate or waive them with the starter replacement if you proceed with the service.
Putting it all together
Combining parts and labor, a typical starter replacement for a 2007 Chrysler 300 is in the ballpark of $300 to $650. Higher-end parts, longer labor times, or charging areas can push the total higher. Always request itemized quotes from multiple shops to compare parts quality, warranties, and total costs.
Summary
The 2007 Chrysler 300’s starter replacement cost hinges on engine type (3.5L vs 5.7L), part quality (remanufactured vs new), core charges, and local labor rates. Expect a total in the low to mid hundreds for most cases, with potential to exceed $650 in high-cost regions or for premium parts. To ensure you get a fair price, obtain multiple written estimates, confirm compatibility with your exact engine, and inquire about warranty terms.