The typical total for replacing the camshaft position sensor on a 2007 Honda Odyssey is usually between about $150 and $350 when using aftermarket parts and a standard independent shop. If OEM parts from a dealer are used or you’re in a high-cost area, the price can push toward the $400–$500 range, and DIY work can lower the cost further by eliminating labor charges.
What the sensor does and why replacement is needed
The camshaft position sensor monitors the position and speed of the camshaft and sends timing data to the engine computer to manage ignition and fuel delivery. When it fails, drivers may see a check engine light, rough idle, misfires, poor acceleration, reduced fuel economy, or even a no-start condition. On the 2007 Odyssey (3.5L V6, J35A), access is moderate but may require removing some surrounding components for proper replacement.
Cost range and factors
Below is a general breakdown of the main cost components and the factors that affect the final price.
- Parts: The sensor itself can be aftermarket or OEM. Aftermarket sensors typically run about $20–$60, while OEM/dealer parts usually run $60–$120. Some repairs also include a connector seal or harness work, which can add a little more.
- Labor: Replacing the sensor typically takes 0.5–2 hours, depending on access and whether adjacent components must be moved. Labor rates commonly range from about $75–$150 per hour, so total labor can be roughly $40–$300.
- Diagnostics/fees: Some shops charge a diagnostic fee or a shop supply fee if diagnosis is performed but you don’t proceed with the repair. Expect $0–$100 in such cases.
Overall, for an independent shop using aftermarket parts, a typical total tends to fall in the $150–$350 range. Using OEM parts or a dealer in a high-cost area can push the total toward $400–$500 or more, while DIY can reduce the cost further if you supply the part and perform the work yourself.
DIY vs professional service
For do-it-yourselfers, replacing the CMP sensor can save labor costs, but access difficulty, wiring harness clips, and ensuring correct orientation warrant caution. Consider these general steps and safety notes, and consult your service manual for exact instructions for the 2007 Odyssey's V6.
Access and replacement considerations
- Park on a level surface, engage parking brake, and disconnect the negative battery terminal to prevent shorts.
- Locate the camshaft position sensor on the engine; on the 3.5L V6 (J35A) it is typically mounted near the cylinder head and may require removing or moving nearby components for access.
- Disconnect the electrical connector, remove the sensor mounting bolts, and carefully pull out the old sensor.
- Install the new sensor with the correct orientation and seal, torque the bolts to spec, reconnect the wiring harness, and reassemble any components you removed.
- Reconnect the battery, clear any stored codes with a scan tool, and take the vehicle for a test drive to verify proper operation.
Note: If you’re not comfortable with electrical work or engine access, hiring a professional is advisable. Proper installation is essential to avoid misdiagnosis or engine timing issues.
How to get a fair estimate
To ensure you receive a fair price, use these tips when requesting quotes from shops or a Honda dealer.
- Ask for a separate parts price (OEM vs aftermarket) and a separate labor price, with an itemized line for any diagnostic fees.
- Request a written estimate that includes taxes, shop supplies, and disposal fees where applicable.
- Check warranty terms on both parts and labor (typical coverage is 12 months/12,000 miles for labor and a comparable period for parts, though terms vary by shop and part source).
Prices vary by region and market conditions, but a typical range for this repair in the U.S. remains roughly $120–$500 depending on parts choice, labor rates, and whether the work is performed by a dealer or independent shop.
Summary
Replacing the camshaft position sensor on a 2007 Honda Odyssey is a moderate-cost repair with a broad price range. Independent shops using aftermarket parts usually charge about $150–$350 in total, while OEM parts or dealership service in higher-cost areas can bring the bill to $400–$500 or more. DIY can lower costs if you have the tools and know-how, but professional service is recommended if you’re unsure about electrical connections or access. Always obtain multiple quotes and verify what is included in the price before proceeding.
What are the most common problems with a 2007 Honda Odyssey?
Owner Reported Trouble Spots
- Climate System. AC compressor, blower (fan) motor, condenser, evaporator, heater system, automatic climate system, electrical failure, refrigerant leakage.
- Engine Minor.
- Suspension/Steering.
- Body Hardware.
- Exhaust.
- Paint/Trim.
- Engine Cooling.
- Brakes.
Ask about result
How much does it cost to replace the camshaft position sensor on a Honda Odyssey?
between $696 and $1,041
The average cost for a Honda Odyssey Camshaft Position Sensor Replacement is between $696 and $1,041 but can vary from car to car.
Ask about result
Can I still drive my car with a bad camshaft position sensor?
While you can drive with a bad camshaft position sensor, it's not recommended. Continuing to drive with a faulty sensor can lead to other more costly problems, and it could potentially cause your engine to stall while you're on the road, causing danger to yourself and others.
Ask about result
What are the 7 symptoms of a bad camshaft position sensor?
Position sensor is power loss. If the sensor isn't giving accurate info to the ECU. Your engine struggles to get the timing right for fuel injection. And spark.