Approximately 4.5 quarts of engine oil (with filter) are needed for the 2014 Honda CR-V's 2.4L engine.
The 2014 CR-V uses a 2.4-liter inline-four and follows Honda's recommendations for oil grade and capacity. In most markets the oil capacity is about 4.5 quarts with the filter when performing a full oil change, and you should fill to the FULL mark on the dipstick after completing the change. Always verify exact specifications in your owner's manual, as regional variations can apply.
Oil capacity and recommendations
For quick reference, here are the core specs that relate to oil capacity and grade for the 2014 CR-V's 2.4L engine.
- Engine: 2.4-liter inline-four (K-series); standard across US-spec 2014 CR-V.
- Oil capacity (with filter): 4.5 quarts (4.3 liters).
- Recommended oil grade: 0W-20 is standard in most markets; some regions may permit 5W-20. Always follow the owner's manual.
- Maintenance interval: Typical oil-change interval is around 7,500 miles (12,000 km) under normal driving conditions.
Note: Actual capacity can vary slightly if the filter is not replaced or if there are regional engineering changes; always verify with the dipstick after pouring oil.
How to add or check oil
If you're performing an oil change or topping up, follow these steps to ensure you reach the proper level without overfilling.
- Park on level ground and turn off the engine. Let it cool for a few minutes before checking the oil level with the dipstick.
- Remove the dipstick, wipe it clean, reinsert it, and pull it out again to read the current level.
- If adding oil, open the engine oil filler cap on top of the engine and pour a small amount (about 0.25 quart at a time) through a funnel.
- Replace the dipstick and recheck after a few minutes. Repeat until the level reaches the FULL mark, being careful not to overfill.
- Start the engine, run briefly, turn it off, then recheck the level one final time. Add oil in small increments if needed.
Following these steps helps ensure you reach the correct oil level and maintain engine health. Do not overfill, as excess oil can cause foaming and pressure issues.
Summary
In short, expect to use about 4.5 quarts of engine oil (with a new filter) when performing a full oil change on a 2014 Honda CR-V with the 2.4L engine, using the recommended 0W-20 oil in most regions. Always confirm exact capacity from your owner's manual for your specific vehicle and market, and verify the level with the dipstick after filling.