For the 2020 Outlander, oil capacity depends on the powertrain. The gasoline model with the 2.4-liter engine takes about 4.7 quarts of engine oil with a filter, while the Outlander PHEV uses about 3.7 quarts. This guide lays out those figures and what they mean for maintenance and service scheduling.
Engine options in the 2020 Outlander
The 2020 Outlander lineup includes a gasoline version powered by a 2.4-liter four-cylinder engine and a plug-in hybrid (PHEV) variant that combines a 2.0-liter engine with a battery system. Oil capacity varies between these powertrains, so drivers should use the figure that matches their specific model.
Gasoline Outlander (2.4L)
Gasoline-equipped Outlanders built for the 2020 model year use approximately 4.7 quarts of engine oil when performing a standard oil change with a new filter. This capacity accounts for the filter and typical drainage, but exact amounts can vary slightly by engine revision or service procedure.
- Oil capacity: about 4.7 quarts (with filter)
It’s important to replace the oil filter during every change and to verify the oil level with the dipstick after adding oil. Always consult the owner’s manual for the recommended viscosity and any model-specific notes.
Outlander PHEV (2.0L)
The Outlander PHEV, which uses a 2.0-liter engine in combination with its hybrid system, requires roughly 3.7 quarts of engine oil for a full change with a new filter. This smaller capacity reflects the lighter engine and different lubrication needs of the hybrid setup.
- Oil capacity: about 3.7 quarts (with filter)
As with the gasoline variant, use the correct oil grade and filter, and refer to the manual for any PHEV-specific maintenance notes or service interval guidance.
Practical tips for your oil change
Whichever version you own, follow these general guidelines to ensure a proper oil change and accurate oil level checks. Use the recommended oil grade for the climate and mileage, replace the filter, and run the engine to operating temperature before draining to ensure complete drainage.
Summary
The 2020 Mitsubishi Outlander’s oil capacity depends on the powertrain: about 4.7 quarts for the gasoline 2.4L engine and about 3.7 quarts for the Outlander PHEV’s 2.0L engine. Always verify with the owner’s manual and use the correct filter and oil grade for your specific model and driving conditions.
What kind of oil does a 2020 Mitsubishi Outlander take?
0W-20 Synthetic. 5W-20/5W-30 Conventional Grades.
What kind of oil does a Mitsubishi Outlander 2.4 take?
Most current Outlander models require 0W-20 full synthetic oil, with capacity ranging from 4.2 to 4.8 quarts depending on engine size. The Outlander Sport 2.4L engine may specify 5W-30.
What are the common repairs for outlanders?
Mitsubishi Outlander Common Problems New York Drivers Should Know
- Transmission hesitation or jerking in certain driving conditions.
- Engine roughness or stalling after high mileage.
- AC not working during the hot summer months.
- Electrical issues such as malfunctioning lights or sensors.
How much oil does a 2020 Mitsubishi Outlander 2.4 L take?
4.9 quarts
Oil Grade: SN
| Viscosity: | 0W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.9 quarts (with filter). After refill check oil level. |
| Torque: | 26-32 ft/lbs (Oil Drain Plug) |