The 2017 Honda Odyssey’s 3.5-liter V6 requires 5.7 quarts of engine oil when you perform an oil change with the filter replaced, using 0W-20 full-synthetic oil.
Honda’s Odyssey lineup from 2017 uses a 3.5L V6 engine, and the oil capacity is a common question for owners performing routine maintenance. The following guide provides the exact capacity, the recommended oil type, and a practical, step-by-step approach to changing the oil safely and correctly.
Engine and capacity
The 2017 Odyssey runs on Honda’s 3.5-liter V6 engine. The official oil capacity for a full oil change (including a new filter) is 5.7 quarts (about 5.4 liters). Honda specifies 0W-20 synthetic oil for normal driving conditions to ensure optimal lubrication and fuel efficiency. Always confirm the exact specification in your owner's manual or with a Honda dealer if you use an alternative oil product or operate under unusual climate conditions.
With the right oil and filter in hand, you can proceed confidently through the change, knowing you’re meeting the manufacturer’s requirements and maintaining engine health.
What you'll need to perform an oil change
Preparing the right supplies before you start helps ensure a clean, efficient oil change and accurate topping off at the end.
- 5.7 quarts of 0W-20 full-synthetic engine oil
- New oil filter compatible with the 3.5L V6 Odyssey
- Oil drain pan, funnel, rags or paper towels for spills
- Tools: socket/wrench set, car jack and stands or ramps, and a torque wrench if available
- Gloves and safety glasses
Having the correct quantity of oil and a fresh filter, along with the right tools, helps ensure a thorough, clean change and proper lubrication after the job is done.
Step-by-step oil change process
Below is a practical sequence for performing an oil change on a 2017 Odyssey. Always follow your owner's manual for vehicle-specific instructions and safety precautions.
- Warm the engine briefly, then park on level ground and engage the parking brake. Raise the vehicle on a jack and secure it with stands or ramps.
- Place the drain pan beneath the oil pan, remove the drain plug, and let the oil drain completely.
- Remove the old oil filter. Be prepared for some oil to spill; have rags handy. Install the new filter by hand until it is seated, then follow the filter manufacturer’s guidance for snugness.
- Replace the drain plug with a new washer if required, ensuring it is snug but not overtightened.
- Pour in the new oil: 5.7 quarts of 0W-20. Use a funnel to minimize spills and check for leaks once the cap is secured.
- Start the engine and run for about a minute, then turn it off and wait a few minutes. Check the oil level with the dipstick and top off as needed to reach the full mark.
- Dispose of the used oil and old filter at an approved recycling facility or auto shop that accepts used oil.
After completing the change, recheck for leaks and ensure the oil level remains at the full mark on the dipstick during a subsequent check.
Maintenance notes and schedule
For the 3.5L Odyssey, Honda commonly recommends 0W-20 full-synthetic oil with a typical change interval of about 7,500 miles under normal driving. If you frequently drive in severe conditions—such as heavy traffic, extreme temperatures, or frequent short trips—a shorter interval may be appropriate (3,750–5,000 miles). Always refer to the owner’s manual and rely on the vehicle’s Oil Life monitor for the most accurate scheduling based on actual usage.
Adhering to the recommended maintenance schedule helps protect engine performance and longevity, and using the correct oil grade supports overall efficiency and emissions performance.
Summary
The 2017 Honda Odyssey requires 5.7 quarts of 0W-20 full-synthetic engine oil when performing an oil change with a new filter. Gather the right oil, a new filter, and the proper tools, then follow the step-by-step process to complete the change safely. Use the vehicle’s Oil Life monitor and the owner’s manual to guide future maintenance and keep the engine running smoothly for miles to come.