For the 2013 Honda Accord, engine oil capacity depends on the engine: the 2.4-liter four-cylinder requires 4.5 quarts of oil (with a filter), while the 3.5-liter V6 requires 5.7 quarts (with a filter).
In practice, the correct amount varies by engine option, and these figures assume a standard oil change with a new filter and full drainage of the old oil. Always consult the vehicle’s owner's manual for the exact specification for your trim and production region, since there can be small variations.
Engine options and oil capacity
Below are the standard capacities for the two engine options in the 2013 Accord, based on a typical oil change with a fresh filter.
- 2.4 L four-cylinder engine: 4.5 quarts (with filter)
- 3.5 L V6 engine: 5.7 quarts (with filter)
Bottom line: match the oil quantity to your engine type, then confirm the level with the dipstick after filling and start the engine to circulate the oil. If you drain the oil completely and replace the filter, start with the listed amount and add gradually as needed to reach the proper level.
Notes on oil grade and maintenance
Refer to the owner's manual for the recommended oil grade and service intervals. The 2.4 L engine is commonly paired with a low-viscosity synthetic oil, while the 3.5 L V6 may use a similar grade depending on climate, so always verify the specification for your specific vehicle.
Summary
The 2013 Honda Accord uses about 4.5 quarts of oil for the 2.4 L four-cylinder and about 5.7 quarts for the 3.5 L V6, both with a new filter. Check your exact manual to confirm these figures for your specific car, and verify the final level with the dipstick after refilling.