The Honda Odyssey typically requires about 5.5 quarts of engine oil when performing a full oil change with a new filter. For most modern 3.5-liter V6 Odysseys, plan on about 5.5 quarts, but always verify with your specific model year and trim in the owner’s manual or with a dealer.
Capacity can vary slightly by year and service practices. If you do not replace the oil filter, you might need around 4.8 quarts. Always check the dipstick and follow the vehicle-specific recommendations in your manual.
Official specifications for the Odyssey
Honda's service literature for the 3.5-liter V6 used in most Odyssey generations lists an oil capacity of 5.5 quarts (5.2 liters) with the filter installed. Without the filter, the capacity is commonly cited as about 4.8 quarts (4.6 liters). Use this as a baseline, but always confirm for your exact year and engine variant in the owner's manual or a trusted service bulletin.
Year-to-year considerations
While the 3.5L V6 powerplant carries over across many Odyssey generations, small differences in oil grade recommendations and drain plug hardware can occur. In practice, the practical oil-fill target for a standard Odyssey oil change remains around 5.5 quarts with a new filter, using a modern synthetic 0W-20 lubricant for most regions. Check your manual for any year-specific notes, especially if you’re running in extreme heat or cold.
Oil grade and filter guidance
Most modern Odysseys call for 0W-20 full synthetic oil and a compatible oil filter. Always confirm the recommended viscosity and filter type for your exact model year in the owner’s manual or by asking a dealer tech. Using the specified oil ensures proper engine protection and fuel efficiency.
What you’ll need for an oil change
If you’re planning an oil change, gather the items listed below before you begin.
- 5.5 quarts of 0W-20 synthetic motor oil (check manual for your exact grade)
- Oil filter compatible with the Honda Odyssey
- Oil drain pan and a funnel
- Ratchet and appropriate socket for the engine drain plug
- New drain plug crush washer (optional but recommended)
- Clean rags or shop towels and gloves
With these items on hand, you’re ready to perform a standard oil change following proper safety practices and local disposal guidelines.
Steps for a basic oil change
Here’s a straightforward sequence you can follow for a typical oil change on a Honda Odyssey.
- Warm up the engine briefly to help the oil drain smoothly, then turn off and safely lift the vehicle if required.
- Place the drain pan underneath the oil pan, remove the drain plug, and let the oil drain completely.
- Remove the old oil filter and replace it with a new one, lightly coating the gasket with fresh oil.
- Reinstall the drain plug and tighten to the factory specification (do not overtighten).
- Pour in 5.5 quarts of the recommended oil using a funnel, then replace the oil cap.
- Start the engine, run for a few minutes, then turn off and check the oil level with the dipstick. Add more oil if needed to reach the FULL mark.
- Check for leaks, clean up any spills, and dispose of used oil at an appropriate recycling location.
By following these steps, you’ll complete a standard oil change and ensure the engine has the correct lubrication for ongoing reliability.
Practical reminders and tips
Keep a note of the service date and odometer reading for future maintenance reminders. If you use a different oil grade or alternative brand, make sure it meets Honda’s specifications for your model year. Always regulate oil changes according to the maintenance schedule in your owner’s manual and local driving conditions.
Summary
For most Honda Odyssey engines with the 3.5-liter V6, plan on about 5.5 quarts of engine oil when performing a full oil change with a new filter. Without replacing the filter, the requirement is typically around 4.8 quarts. Use the oil grade specified in your manual (commonly 0W-20 synthetic for modern Odysseys) and verify exact capacity and procedure for your year. Regular checks with the dipstick and adherence to Honda’s maintenance guidelines will help maintain engine health over the vehicle’s life.
How many quarts of oil does a 3.5 l Honda Odyssey take?
4.5 quarts
The 3.5L V6 typically requires about 4.5 quarts with a filter change; always verify the exact capacity in your owner's manual. Our technicians measure fill precisely to ensure proper oil pressure and to avoid overfill, which can harm engine seals and performance.
What kind of oil does a Honda Odyssey 3.5 take?
Mobil 1 – High Mileage 0W-20 Full Synthetic Motor Oil, Extends Engine Life, 5 Quart (Part No. 15015)
Can I put 5 quarts of oil in a Honda Odyssey?
How much oil does a 2025 Honda Odyssey need? The 3.5L V6 typically requires approximately 4.5 to 5.0 US quarts (about 4.3–4.7 liters) including the oil filter during an oil change. Exact capacity can vary slightly with filter choice; technicians fill to the manufacturer's specification and verify with a dipstick check.
Can I put 5W-30 in a Honda Odyssey?
Valid thru 5/4 on 5-qt.