About five quarts of engine oil with the filter installed, for a typical 4.7L V8. Always verify with your vehicle’s manual for your exact year and configuration.
Oil capacity by 4.7L V8 variant
The 4.7-liter V8 family used by Chrysler and Dodge includes two main variants: PowerTech and Magnum. For most model years in this lineage, the standard oil capacity is five quarts (with a new filter) during an oil change. Exact capacities can vary slightly based on the engine variant, oil filter size, and whether auxiliary components are drained or removed during service.
- 4.7L PowerTech V8: typically 5 quarts with filter.
- 4.7L Magnum V8: typically 5 quarts with filter.
- Note: Some service configurations or unusually large filters can cause small deviations; always confirm by checking the dipstick after refilling and consult the owner's manual for your exact vehicle.
Practically, plan on using about five quarts of oil during an oil change and top off to the full mark after starting the engine and letting it settle. If you used a much larger filter, you may need a little more, but 5 quarts is the standard starting point.
Oil change procedure for the 4.7L V8
Here is a typical sequence to perform a standard oil change, with steps designed to ensure you use the correct amount of oil and avoid leaks.
- Warm the engine briefly to make the oil drain more completely, then park on level ground and apply the parking brake.
- Place a drain pan beneath the oil pan, remove the drain plug, and allow the old oil to drain fully.
- Remove and replace the oil filter, applying a light coat of oil to the gasket on the new filter before installation.
- Reinstall the drain plug and torque to the specification in your manual.
- Fill with approximately 5 quarts of the recommended oil (check your manual for the exact grade and capacity).
- Start the engine, run for a minute, then turn it off and wait a moment before checking the dipstick; add small amounts as needed to reach the full mark.
- Check for leaks around the filter and drain plug, then replace the filler cap and reset the oil-change reminder if applicable.
Carrying out the steps carefully helps ensure proper lubrication and an accurate oil level.
Tips to ensure an accurate fill
After you complete an oil change, verify the level with the dipstick on a level surface and with the engine at rest. Use the correct oil type (grade and viscosity) as specified in your manual, and avoid overfilling, which can cause foaming and engine damage.
- Use the oil grade recommended for your vehicle (often 5W-20 or 5W-30 for many 4.7L engines).
- Always replace the filter with a new one of the proper specification.
- Double-check that the drain plug is tight and that there are no leaks around the filter.
Summary
The 4.7L V8 commonly holds about five quarts of oil with a new filter installed. This aligns with typical service data for the PowerTech and Magnum variants. Always corroborate with the owner’s manual and use the dipstick to confirm the final level after refilling.