About 5.5 quarts of engine oil (including the filter) for a full oil change on the 2022 Kia Telluride’s 3.8-liter V6.
The 2022 Telluride uses a 3.8-liter V6 engine, shared with Kia’s and Hyundai’s other midsize SUVs. The vehicle’s official specification places the oil capacity at roughly 5.5 quarts when installing a new filter, with about 5.0 quarts if the filter is not replaced. The exact figure can vary slightly by production date, trim, and service bulletin updates, so always verify with your owner's manual or the vehicle’s oil-fill sticker.
Engine oil capacity and maintenance basics
The oil capacity numbers below reflect typical factory specifications for the 2022 Telluride’s V6. They are intended as a general guide for full-system changes, including a new filter. Always confirm the precise specification for your vehicle year and trim before an oil change.
- With filter: about 5.5 quarts (roughly 5.2 liters).
- Without filter: about 5.0 quarts (roughly 4.7–5.0 liters).
These figures describe the total fill after a complete drain and fill with a new filter. If you drain the oil without replacing the filter, you’ll use the lower figure; replacing the filter adds to the capacity.
Recommended oil type and service tips
Using the correct viscosity and synthetic quality is essential for performance and warranty coverage. For the 2022 Telluride, Kia typically recommends a full-synthetic engine oil with a viscosity of SAE 5W-30. In extreme climates or under local guidance, check the owner’s manual or consult a Kia dealer for any climate-specific recommendations. Always verify the exact specification on the oil fill cap or the manual.
- Viscosity: SAE 5W-30 is commonly recommended.
- Oil type: Full synthetic is preferred by Kia/Hyundai for this engine.
- Change interval: Usually every 7,500–10,000 miles under normal conditions; more frequent in severe driving conditions.
Conclusion: For a complete oil change on the 2022 Kia Telluride with the 3.8L V6, expect to use about 5.5 quarts of oil with a new filter. If you’re not replacing the filter, plan for around 5.0 quarts. Confirm the exact capacity and viscosity in your owner's manual or on the vehicle’s oil-fill cap.
Summary
In short, the 2022 Kia Telluride takes approximately 5.5 quarts of engine oil when performing a full change with a filter, using the typical 5W-30 synthetic oil. Always check the owner’s manual and the oil cap on your specific vehicle year and trim to confirm exact requirements and intervals.