Approximately 5 quarts of engine oil are needed for the 2020 Murano's 3.5 L V6, typically 5.0–5.1 quarts with a new filter.
The question focuses on the standard oil capacity for routine maintenance on the 2020 Murano. Exact amounts can vary slightly depending on whether the oil filter is changed and the engine’s condition. Always verify the precise capacity in the owner's manual and confirm the final oil level with the dipstick after an oil change.
Official oil capacity for the 3.5 L V6
The following figure reflects the capacity commonly cited for an oil change with a new filter.
- Oil capacity with the filter replaced: about 5.1 quarts (roughly 4.9–5.1 quarts depending on drain and pan conditions).
In practice, starting with around 5 quarts and then verifying the level with the dipstick after the engine runs is a reliable approach. Adjust as needed to reach the Full mark.
Practical steps to ensure the correct fill
Before performing the fill, follow these steps to ensure accuracy and engine safety.
- Park on level ground, turn off the engine, and allow the oil to settle for a few minutes.
- Check the oil level with the dipstick after removing it, cleaning it, reinserting it, and removing it again to read the level.
- If the level is below the Full mark, add oil in small increments (about 0.5 quart at a time), then recheck.
- Use the oil type recommended in the owner's manual (usually synthetic 0W-20 or 5W-30 depending on climate) and ensure the engine is not overfilled.
Following these steps helps ensure you fill to the correct capacity and protect the engine from under- or over-filling.
Summary
The 2020 Murano's 3.5 L V6 typically takes about 5 quarts of engine oil with a new filter, with the exact amount confirmed by the dipstick after filling. Always consult the owner's manual for the official specification and use the recommended oil viscosity for your climate.