Five quarts of oil (about 4.7 liters) are required for a full oil change on the 2017 Pacifica with the 3.6 L Pentastar engine, using SAE 0W-20 full-synthetic oil.
The 3.6 L engine in the 2017 Pacifica uses a standard oil capacity of 5 quarts with the filter. This article outlines the official capacity, the recommended oil type, and practical maintenance steps to keep the engine properly lubricated.
Oil capacity and oil type
Key facts about the engine oil for the 2017 Pacifica 3.6 L are summarized below.
- Oil capacity: 5 quarts (4.7 liters) with filter
- Recommended oil viscosity: SAE 0W-20 full synthetic
- Standard oil change steps: replace the oil filter, pour in 5 quarts, start the engine, run briefly, then recheck the level with the dipstick
Bottom line: the official capacity is 5 quarts with a new filter, and you should use 0W-20 full synthetic oil. After adding oil, verify the level on the dipstick and adjust as needed to reach the full mark.
Maintenance guidelines
To keep the engine well-lubricated and within specification, consider these practical guidelines.
- Oil level should be checked when the engine is cold or after it has been off for at least 5–10 minutes to ensure an accurate reading
- Use high-quality 0W-20 synthetic oil that meets Chrysler specifications and current API/ILSAC standards
- Oil change interval for normal driving with synthetic oil is typically around 7,500 miles (12,000 km); more frequent changes are advised under severe driving conditions
In practice, perform the oil change with a new filter, add 5 quarts of oil, start the engine to circulate, and then recheck the level. Top off as needed to bring the dipstick to the full line.
Summary
The 2017 Chrysler Pacifica’s 3.6 L engine requires 5 quarts (4.7 liters) of SAE 0W-20 full-synthetic oil for a complete oil change, including a new filter. Always consult the owner’s manual for the exact specification and adhere to recommended service intervals to maintain engine health.