The 2015 Nissan Altima with the 2.5-liter engine holds about 4.8 quarts of engine oil when performing a standard change with a new filter.
Official specification and practical guidance
For the 2.5-liter QR25DE engine used in the 2015 Altima, Nissan lists an oil capacity of 4.8 quarts (approximately 4.6 liters) when completing a full oil change with a new filter. This figure is the standard fill used by most service providers. Always confirm with your owner's manual and use the dipstick to verify the exact level after an oil change, as small variations can occur by production date or measurement method.
Key figures from the official spec and common maintenance practices:
- Oil capacity with filter: 4.8 quarts (4.6 L)
In practice, following the standard change procedure and using a new filter will typically require about 4.8 quarts of oil. After pouring in the oil, run the engine briefly, then recheck the level with the dipstick and top up if necessary to reach the full mark.
Oil change guidance for the Altima 2.5 L
If you plan to change the oil yourself, follow this practical sequence to ensure proper filling and level.
- Warm the engine to operating temperature, then park on level ground and turn off the engine.
- Raise the vehicle safely and place a drain pan beneath the oil pan.
- Remove the drain plug and allow the old oil to drain completely.
- Remove and replace the oil filter, lightly coating the gasket with fresh oil.
- Reinstall the drain plug and snug it to the manufacturer’s specification.
- Pour in about 4.8 quarts of fresh oil (with a new filter), then start the engine and run for a minute to circulate the oil.
- Turn off the engine, wait a few minutes, and check the oil level with the dipstick; top up to the full mark if needed.
Bottom line: the standard oil-fill for a complete change on the 2015 Altima 2.5 L is about 4.8 quarts, but always verify on the dipstick after the run-in and refer to the owner’s manual for any year-specific notes.
Summary
The 2015 Nissan Altima 2.5 L uses roughly 4.8 quarts of engine oil for a full change with a new filter. Use the dipstick to confirm the level after filling, and consult the owner's manual for any model-year variations or service bulletins. Regular oil changes with the correct quantity help maintain engine performance and longevity.
Which engine oil is best for Nissan Altima 2015?
For a 2015 Nissan Altima, Nissan recommends using SAE 0W-20 or 5W-30 full synthetic oil. This recommendation is based on the engine's design and the need for optimal performance and fuel efficiency.
What kind of oil and how many quarts for a 2015 Nissan Altima 2.5 L?
Oil Grade: API*
| Viscosity: | 0W-20, 5W-30 (All TEMPS) - SAE 0W-20 is preferred. |
|---|---|
| Capacity: | 4.9 quarts (with filter). After refill check oil level. |
| Torque: | 25 ft/lbs (Oil Drain Plug) Install a new washer on the drain bolt. Only use an OE drain plug. |
What is the best oil for Nissan Altima 2.5 L?
Picking the right oil for your Nissan Altima is vital. 5W30 synthetic oil stands out as the top pick among the many choices. When planning your next Nissan Altima oil change near Bellevue, keep these reputable brands in mind: Castrol Edge High Mileage Full Synthetic Motor Oil 5W-30.
What's the fastest Altima?
2021 Altima Engine Performance
| 2021 Nissan Altima Engine Specs | ||
|---|---|---|
| Trim Levels | Engine Size | Top Speed |
| Platinum | 2.5L 4-cylinder | 119mph (Estimated) |
| SL | 2.5L 4-cylinder | 119mph (Estimated) |
| SR VC-TURBO™ | 2.0-L VC-Turbo™ 4-cylinder | 130mph (Estimated) |