Approximately 6 quarts of engine oil are required for a full oil change on the 2013 BMW 328i xDrive, including the oil filter. This figure applies to the N20 2.0L turbo engine used in that model year and drivetrain combination.
The 2013 328i xDrive uses the N20 2.0-liter turbocharged inline-four engine. Oil capacity figures are intended for a standard drain-and-fill with a new oil filter, and real-world values can vary slightly depending on the filter type and any additional accessories involved. Always verify the exact spec in the owner's manual or the BMW service data for your vehicle configuration.
Oil capacity for the 2013 BMW 328i xDrive
Here are capacity figures that help place the 328i xDrive in the context of related models from the same era. The values refer to engine oil capacity including the filter, which is the common measurement used during a complete change.
- 2013 BMW 328i (N20) – 6.0 quarts (approximately 5.7 liters)
- 2013 BMW 328i xDrive (N20) – 6.0 quarts (approximately 5.7 liters)
- 2013 BMW 335i (N55) – 7.0 quarts (approximately 6.6 liters)
These figures should be treated as general guidance. For the exact specification for your car, consult the owner's manual or a BMW dealership service data sheet. After performing an oil change, ensure the level is correct using the dipstick or the vehicle’s oil level display.
How to perform an oil change
To ensure you reach the correct oil level and maintain engine health, follow these practical steps. The sequence below reflects a standard drain-and-fill procedure for a 2013 BMW 328i xDrive equipped with the N20 engine.
- Warm up the engine briefly, then turn it off and secure the vehicle on level ground.
- Place a drain pan beneath the engine and remove the drain plug to let old oil drain completely.
- Remove and replace the oil filter with a new one designed for BMW engines.
- Reinstall the drain plug and pour in 6.0 quarts of fresh engine oil (adjust only if your manual specifies a different quantity).
- Check the oil level with the dipstick or via the vehicle’s oil level system, then top up in small increments if needed to reach the correct level.
Following these steps helps ensure the engine is properly lubricated and avoids overfilling, which can cause oil foaming or pressure issues. Always use the oil grade recommended by BMW for your climate and driving conditions, and reset the oil maintenance counter if your vehicle supports it.
Notes on oil type and maintenance intervals
While the exact viscosity may vary by climate, many 2013 BMW models use synthetic engine oil meeting BMW LL-01 specifications. Typical options include low-viscosity grades suitable for efficiency and cold-weather performance. Refer to your owner’s manual or a dealer for the precise specification and the recommended service interval for oil changes, which can depend on driving conditions and vehicles equipped with various tech packages.
Summary
For a 2013 BMW 328i xDrive with the N20 engine, plan for about 6.0 quarts of engine oil during an oil change, including the filter. This capacity matches the related non-xDrive variant and is slightly different from higher-performance N55 engines, which typically require about 7.0 quarts. Always verify the exact spec in the owner's manual and perform a level check after the change to ensure the correct fill.
Can 10W-40 oil go in a BMW 328i?
These oils will be any BMW LL-01 rating, any of the Red Line High Performance, and any 10W40 viscosity We would not say to “stay away” from these oils because there is great benefit to their oil performance, but it comes with some trade-offs.
Is 5W30 synthetic oil good for a 2013 BMW 328i?
The proper oil for the BMW 328i is synthetic oil with a grade of 5W-30 for most models.
What type of oil does a BMW 3 series 328i XDrive take?
synthetic oil
So, what type of oil is recommended for the BMW 328i? The Pacific BMW service team in Glendale recommends that you use synthetic oil with a grade of 5W-30. We've got more information on why this is important in the guide below.
How much oil for a 2013 BMW 328i XDrive?
5.3 quarts
Oil Grade: SEO68
| Viscosity: | 0W-30 (All TEMPS) |
|---|---|
| Capacity: | 5.3 quarts (with filter). After refill check oil level. |