The 2008 Dodge Grand Caravan with a 3.8-liter V6 takes about 5 quarts of engine oil for a full change with a new filter.
Understanding this capacity helps you plan maintenance and avoid underfilling or overfilling the engine. The figure above refers to a standard oil change using a fresh filter and oil; always confirm the exact specification for your vehicle in the owner’s manual or service guide, as there can be minor variations by VIN or model year.
Capacity specifics for the 3.8L V6
The following notes summarize the typical oil capacity and related details for this engine family during a standard service.
- Oil capacity with a new filter: about 5 quarts.
- Oil capacity without replacing the filter: roughly 4.5 quarts.
- Recommended oil viscosity: generally 5W-20, with 5W-30 acceptable in warmer climates or per the owner's manual.
These figures provide a practical guide for planning maintenance and ordering the right amount of oil. Your exact vehicle variant may differ slightly, so always verify with official documentation or a trusted dealer.
DIY oil change steps for the 3.8L V6
If you’re performing an oil change yourself, follow these steps to complete the job efficiently and safely.
- Gather supplies: oil that meets the recommended viscosity, a new filter, a drain pan, and basic hand tools.
- Warm up the engine briefly to help oil drain more completely.
- Place the drain pan under the oil pan and remove the drain plug to drain used oil.
- Remove and replace the oil filter with a new one, applying a light coat of oil to the gasket for a proper seal.
- Refill with the correct amount of oil (about 5 quarts with filter), then start the engine, check for leaks, and recheck the dipstick after a few minutes of cooling to ensure full level.
Concluding note: Accurate oil capacity depends on replacing the filter and following the viscosity recommendations. Use the dipstick to confirm the level before driving.
Notes and considerations
Always consult the owner’s manual for the exact specification for your specific Grand Caravan model, as capacity can vary with different engine assemblies or trim levels. If you’re unsure, contact a dealer or a trusted mechanic to confirm the current requirement.
Summary
For the 2008 Dodge Grand Caravan with a 3.8L V6, plan for about 5 quarts of engine oil during a standard oil change with a new filter. If you don’t replace the filter, you might need around 4.5 quarts. Use the viscosity recommended by the manual (typically 5W-20) and verify the level with the dipstick after refilling. Always refer to the owner’s manual for your exact configuration.
What kind of oil goes in a 2008 Dodge Grand Caravan?
Oil Grade: API*
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 5 quarts (with filter). After refill check oil level. |
| Torque: | 20 ft/lbs (Oil Drain Plug) |
What oil goes in a 2008 Chrysler 3.8 liter?
Valvoline – Advanced Full Synthetic 5W-20 Motor Oil, Maximizes Engine Life, 1 Quart (Part No. VV927)
What kind of oil does a Dodge Caravan 3.8 take?
5 Liters Of German RAVENOL SFE 5w20 Motor Oil - Meets the Chrysler MS-6395 motor oil quality standard and viscosity required for the Dodge Grand Caravan 3.8L gasoline engine.
What oil does a 3.8 L V6 take?
AMSOIL 5W-20 100% Synthetic High-Mileage Motor Oil.