About 6 quarts of engine oil (roughly 5.7 liters) are required for a full oil change on a 2007 Durango equipped with the 4.7 L V8. If you do not replace the oil filter, or you drain only part of the oil, the amount needed can be slightly different.
The 4.7 L V8 used in the 2007 Durango is commonly cited with a capacity of 6 quarts with the filter installed and drained, and about 5 quarts without the filter. This article provides the official capacity figures, practical tips, and how to verify the proper fill level for this engine.
Capacity details
The following items summarize the official oil capacity figures you should know when performing an oil change on the 2007 Durango’s 4.7 L V8.
- 6 quarts (5.7 L) of engine oil when performing a full oil change and replacing the filter.
- 5 quarts (4.7 L) if you drain the oil but do not replace the filter (capacity without the filter).
In practice, most DIY and dealership manuals assume you will replace the filter, so plan on about 6 quarts. Always verify by checking the dipstick after filling to the correct level.
Oil type and change recommendations
Knowing the right oil type and follow-up habits helps ensure the 4.7 L V8 runs smoothly between changes. The Durango’s engine is typically lubricated best with a standard viscosity unless your climate or manual specifies otherwise.
- Recommended viscosity: SAE 5W-30 for most temperatures. Some climates or dealer recommendations may allow 5W-20; always check the owner's manual for your exact climate and driving conditions.
- Oil type options: conventional 5W-30 is common, with synthetic 5W-30 also acceptable for longer drain intervals or heavy use.
- General change guidance: follow the owner’s manual for interval timing, and use a new filter with each oil change. After filling, recheck with the dipstick and top off as needed.
Tip: Always verify the fill level with the dipstick after an oil change and avoid overfilling, which can cause engine complications.
Practical steps for an oil change
Here is a straightforward sequence to ensure the Durango’s oil change is done correctly and safely.
- Warm the engine to operating temperature to allow the oil to drain more fully.
- Drain the old oil completely and remove the oil filter; replace with a new filter installed securely.
- Pour in the new oil in increments, starting with 5 quarts and then checking the dipstick to determine if more is needed to reach the full mark.
- Run the engine for a minute, turn off, wait a few minutes, and recheck the dipstick. Add oil in small amounts if necessary until at the full mark.
Note: If you’re unsure about the exact oil grade for your climate or your vehicle’s condition, consult the owner’s manual or a trusted mechanic before proceeding.
Summary
The 2007 Dodge Durango with the 4.7 L V8 generally requires about 6 quarts of oil when performing a full change with a new filter (roughly 5.7 liters), and about 5 quarts if the filter is not replaced. Use SAE 5W-30 (conventional or synthetic as appropriate for your climate) and always verify the fill level with the dipstick after adding oil. Following the manual’s guidance ensures proper lubrication and engine longevity.