The TPMS light on a Honda Civic can be reset by inflating all tires to the recommended cold pressures and then re-learning the sensors either with a dedicated TPMS reset button (if your model has one) or through the vehicle’s calibration menu, followed by a drive at highway speeds to complete the relearn.
Tire-pressure monitoring resets are model-year dependent. Civics use direct TPMS sensors in each wheel or, in some cases, an indirect system that relies on wheel-speed data. If a tire is underinflated, a sensor is faulty, or tires were recently rotated or replaced, the warning can come on again. The following routes cover the most common methods used on recent Civic models.
Two common reset routes for Honda Civics
Choose the method that matches your model year and trim. If your car has a dedicated TPMS button, use that first; otherwise, use the instrument cluster/menu-based calibration.
Method A — Using the TPMS reset button (if equipped)
Use this approach if your Civic has a physical TPMS reset button located under the steering wheel, in the kick panel, or in the glove box.
- Ensure all tires are inflated to the recommended cold pressures listed on the driver’s door jamb placard.
- Turn the ignition to ON with the engine OFF (ready position for some models).
- Locate the TPMS reset button and press and hold it until the TPMS indicator light on the dash blinks or displays a confirmation (varies by year).
- Release the button and drive at highway speeds (about 50 mph or higher) for roughly 10 minutes to complete the relearn.
Once completed, the TPMS light should go out. If it stays lit, try the calibration route below or have the system inspected for sensor or valve issues.
Method B — Calibrating via the instrument cluster/menu (for models without a reset button or with newer trims)
Many Civics manufactured in recent years use the vehicle’s settings menu to re-learn TPMS sensors. Follow these steps if your model relies on the digital interface.
- Check all tires and inflate them to the recommended cold pressures.
- Turn the ignition ON and ensure the engine is off.
- Access the vehicle settings or TPMS section on the instrument cluster or infotainment display (path varies by year; look for Tire Pressure Monitoring, TPMS, or Calibration).
- Select Initialize, Relearn, or Calibration, then confirm your choice.
- Drive at highway speeds for about 10–15 minutes to complete the relearn process.
After completing the calibration, the TPMS light should turn off. If the light remains, further inspection of sensors or tires may be required.
What to do if the light stays on
If the TPMS light remains illuminated after attempting both reset methods, consider the following steps to diagnose common causes:
- Recheck all tire pressures with a gauge to ensure they’re still at the recommended levels when cold.
- Inspect tires for slow leaks, punctures, or damaged valve stems and replace or repair as needed.
- Be aware that a failed TPMS sensor or battery in a wheel could trigger the warning; sensor replacement may be necessary.
- If you recently rotated tires or changed sensors, confirm the new sensors were programmed correctly.
- Visit a tire shop or Honda dealership for a diagnostic scan of the TPMS system; they can identify sensor faults or reprogram the system if needed.
Note that temperature changes can temporarily affect tire pressure readings, and some intermittent warning lights resolve after a few days of normal driving.
Summary
To reset the TPMS light on a Honda Civic, start by bringing all tires to the correct cold pressures. Then either use a dedicated TPMS reset button (if your model has one) or perform a calibration through the vehicle’s settings menu. Drive at highway speeds for about 10–15 minutes to complete the relearn. If the warning persists, check for leaks, faulty sensors, or consult a professional for diagnostics and possible sensor replacement.
How much does Honda charge to reset TPMS?
The average cost for a Honda Accord Tire Pressure Monitoring System Relearn is between $49 and $72. Labor costs are estimated between $49 and $72. This range does not include taxes and fees, and does not factor in your unique location. Related repairs may also be needed.
Why is my TPMS light on but tires are fine on my Honda?
One of the most common reasons for a TPMS light staying on despite the tires being properly inflated is a sensor malfunction. TPMS sensors are typically located inside the tire and can wear out or become damaged over time, particularly if you've hit a curb, driven through a pothole, or been off-road.
How to remove TPMS sensor light Honda Civic?
Steps to Reset Honda TPMS Lights in Newer Models
- From the Home screen, select “Settings”
- Select your vehicle.
- Select “TPMS Calibration”
- Select “Calibrate”
Where is the TPMS reset button on a Honda Civic?
For models with a TPMS Button
If your Honda is equipped with a TPMS button, you'll find it to the left of the steering wheel. Press and hold the button until the warning light blinks twice.