To reset the tire pressure monitoring system (TPMS) on a Honda CR-V, you typically need to bring all four tires up to the recommended cold pressures and then either use a physical TPMS reset button or run a calibration through the vehicle’s settings, followed by a short drive to relearn the sensors. The exact steps can vary by model year and trim, so consult your owner’s manual if you encounter any model-specific differences.
The following guide covers two common methods used on recent CR-V generations and explains how the relearning process works, along with tips for troubleshooting if the light returns after resetting.
Method 1: Reset via the TPMS reset button
If your CR-V has a dedicated TPMS reset button, use this method to manually initiate calibration. The location of the button can vary by year and trim, but it is often found under the left-side lower dash area or inside the glove box.
- First ensure all four tires are inflated to the recommended cold pressures listed on the door jamb placard.
- Turn the ignition to the ON position and confirm that the engine is not running.
- Locate the TPMS reset button and press/hold it until the TPMS indicator light on the instrument cluster blinks or a confirmation message appears.
- Release the button and drive the vehicle for about 10–20 minutes at highway speeds to allow the system to relearn the new pressures.
After completing this method, the TPMS warning light should go out if the relearn was successful. If it remains on, recheck tire pressures and consider repeating the steps or trying the alternative method below.
Method 2: Calibrate via the vehicle’s TPMS settings
Some CR-V models provide a TPMS calibration option through the instrument panel or infotainment system. This method is common on newer trims and some regional versions.
- Verify all four tires are inflated to the recommended cold pressures (as shown on the door placard).
- Power on the vehicle and access the Driver Information Interface or the vehicle’s Settings menu.
- Navigate to TPMS Calibration, Tire Pressure Monitor, or a similar option and select Calibrate/Reset.
- Confirm the calibration and drive normally for 10–20 minutes at speeds above about 40 mph to complete the relearn process.
Calibrating via the on-screen menu is an alternative when the physical reset button is not present or not functioning. If the warning persists after this process, a sensor or wheel issue may be present and professional service may be required.
Model-year variations
TPMS reset procedures can differ between generations of the CR-V. Some earlier models rely almost entirely on the button approach, while newer years emphasize the calibration option in the settings menu. If your vehicle does not respond to the described steps, consult the owner’s manual for year-specific instructions or contact a Honda dealer.
Troubleshooting and tips
Common issues include tire pressures not being at the exact recommended levels, a failing TPMS sensor, or a sensor battery nearing end of life. If the light returns after a successful reset, have the system inspected for sensor faults, damaged wheels, or a slow leak.
What to expect during the relearn process
During relearn, drive with a mix of city and highway speeds. In most cases, the system will complete the relearn after about 10–20 minutes of driving at steady speeds. Do not rely on short trips; longer highway driving helps the sensors register accurately.
Summary
Resetting the CR-V’s TPMS involves ensuring correct tire pressures, then performing a reset either with a physical button or through the vehicle’s TPMS calibration settings, followed by a period of driving to relearn the sensors. Because steps can vary by year and trim, always refer to the owner’s manual for model-specific instructions. If the warning light remains after resetting, have the system inspected for sensor or wheel issues.
In short: correct tire pressures, choose either the button or the settings calibration, drive to relearn, and consult a dealer if the warning persists.