Correct the tire pressures to the recommended level, then reset or calibrate the TPMS in your Honda's system. If the light stays on, there may be a sensor fault or a tire leak that needs service.
Tire Pressure Monitoring System (TPMS) lights warn you when a tire is under-inflated or when the system cannot learn a new tire pressure. Clearing the light generally involves bringing all tires to the correct cold pressures and performing a calibration or relearn through the vehicle’s settings or, in some cases, by driving on a highway to let the system relearn the pressures. Steps vary by model and year, so consult your owner’s manual for model-specific instructions.
Step-by-step approach
This list covers the practical steps you can take to clear the TPMS light on most Honda vehicles.
- Check all tires for proper inflation. Use the cold tire pressure printed on the door jamb placard or in the owner's manual, and inflate to that specification.
- Inspect tires for damage or leaks. Look for nails, punctures, or slow leaks that could cause persistent under-inflation.
- After inflating to the recommended pressure, drive briefly to let the tires warm up and settle. A short drive helps the system recheck pressures.
- If your Honda model supports a TPMS calibration/reset, perform it via the vehicle’s settings: navigate to Settings > Vehicle > TPMS Calibration (or TPMS Learn) and select Calibrate/Reset. Follow on-screen prompts if available.
- After performing a reset, continue driving at highway speeds (around 50 mph / 80 km/h or higher) for 10–20 minutes to complete the relearn process on many models.
Concluding the general steps: when tires are properly inflated and a calibration is completed, the TPMS light should turn off after a few driving cycles. If it does not, or if it comes back on, there may be a sensor fault or a more serious tire issue that requires professional service.
Model-specific reset options for Honda vehicles
There are variations by model and year. The following outlines common paths used by many Honda cars, plus notes when a dealer tool may be required.
- Most modern Honda cars (2013 and newer) support a TPMS calibration or learn option in the on-board menu. Typical path: Settings > Vehicle > TPMS Calibration or TPMS Learn > Calibrate/Reset, then drive to complete the relearn. Ensure all tires are inflated to spec before starting the calibration.
- Some Honda models require you to drive after initiating calibration; a highway drive at about 50 mph (80 km/h) for 10 minutes is commonly recommended to finalize the relearn.
- Older or specialty models may present a dedicated TPMS Learn button behind a panel (often near the glove box or under the dashboard). If present, the procedure is usually to turn the ignition to ON (engine not running), press and hold the Learn button until the indicator blinks or cycles, then drive to complete the relearn. Not all vehicles have this button, so check the owner’s manual.
- If you recently replaced a tire or sensor, you may need a sensor re-learn with a dealer or tire shop using a professional tool. This is especially true if a new sensor was installed or if multiple sensors were replaced.
Note: Always inflate tires to the recommended cold pressure before starting a calibration. If the light stays on after following these steps, or if you notice a tire loss or a damaged sensor, seek service promptly to avoid unsafe driving conditions.
Summary
To clear the TPMS light on a Honda, start by ensuring all tires are at their recommended cold pressures. Then use the vehicle’s TPMS calibration/learn feature if available, or drive at highway speeds to allow the system to relearn. If the light persists after calibration and a full drive cycle, or if you suspect a faulty sensor or tire issue, consult a Honda dealer or qualified tire technician for a diagnostic and possible sensor replacement.