With the ignition on, you can set the time using the car’s built-in clock controls. In most 2008 Civics, this is done either through the standard radio clock buttons or through the navigation/information display, depending on trim.
The 2008 Civic offers two common clock interfaces: a basic stereo clock used in the LX/EX without navigation, and a clock controlled through the vehicle’s information/navigation system in higher trims. The steps differ slightly, but both are designed to be completed without tools.
Common clock interfaces in the 2008 Civic
Option A: Standard radio clock (no navigation)
Use these steps if your car has the basic AM/FM/CD stereo with a dedicated clock button.
- With the ignition on, press and hold the CLOCK button until the digits flash on the display.
- Use the H or HR button to advance the hour digits to the correct value.
- Use the M or MN button to adjust the minute digits.
- Press CLOCK again (or wait a moment) to save the new time to the display.
- Check the display to confirm the correct time is shown.
If these controls don’t respond as expected, verify you’re using the right buttons for your exact stereo variant and consult the owner’s manual for model-specific guidance.
Option B: Clock controlled via navigation or information display
For trims with a navigation system or enhanced information display, the clock is typically set through the system settings.
- Turn the ignition on and press the MENU or SETUP (INFO) button on the dash or center stack.
- Navigate to Clock or Time in the on-screen menu using the selector knob or arrows.
- Adjust the hours and minutes using the appropriate control (dial, up/down arrows, or touchscreen when available).
- Confirm or save the setting, then exit the menu.
- Return to the main screen and verify the updated time is displayed.
The navigation-based clock method can vary slightly by trim; if you can’t locate the Clock option, consult the owner’s manual for the exact menu path.
Troubleshooting the clock
If the clock won’t adjust or loses time, several common issues can be the cause. Start with the basics and move to more involved checks as needed.
- Ensure the ignition is in the correct position (on or accessory) as required by your vehicle’s clock controls.
- Check the radio or clock/memory fuse; a blown fuse can prevent time settings from sticking.
- Inspect the 12V battery and charging system, especially if the time resets after disconnecting power.
- If the display is dim, check brightness/night mode settings and adjust as needed.
- For navigation-equipped models, a software update or recalibration may be needed if the time becomes inaccurate after service.
If time continues to drift or you’re unsure about the fuse and electrical checks, a dealer or qualified technician can diagnose the clock memory circuit and reset it as needed.
Summary
Setting the clock on a 2008 Honda Civic typically involves either the radio’s CLOCK controls for the standard stereo or the vehicle’s settings menu for navigation/information displays. Turn the ignition on, follow the appropriate steps to set hours and minutes, and confirm the new time is displayed. If you encounter variations or issues, consult the owner’s manual for your exact trim or seek professional assistance.
How do I change the time on my Honda dashboard?
And that's all you have to do and will automatically adjust right up there and right over there. Okay now correct time zone.
How do I reset the clock on a 2009 Honda Civic?
Hold the AM FM button till the clock starts blinking. It's blinking now and then one will change the hours. Two will change the minutes. And that is how you change the clock in a 2009 Honda Civic.
How do I change the time on my 2008 Honda Civic?
2006-2011 Honda Model Clock Reset
- Turn on the ignition.
- Press and hold the “clock” button until the time begins to blink.
- Click the “preset 1” button to change the hour and the “preset 2” button to change the minute.
How do you set the clock on a 2007 Honda Civic?
Press the M to set them proper. Minutes when you're done just press the clock button again. And that's it.